Ads
related to: rs422 maximum cable length calculator download
Search results
Results From The WOW.Com Content Network
Data rate versus line length chart, from RS-422 Annex A.1. Several key advantages offered by this standard include the differential receiver, a differential driver and data rates as high as 10 megabits per second at 12 meters (40 ft). Since the signal quality degrades with cable length, the maximum data rate decreases as cable length increases.
English: Data Rate / Line Length chart from RS-422 Annex A. (This chart is not in RS-485). This chart is not an absolute limit, but a conservative guide based on empirical data of 24AWG telephone cable. Cable length may be extended from this chart.
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.
MIL-STD-1553B does not specify the length of the cable. However, the maximum length of cable is directly related to the gauge of the cable conductor and time delay of the transmitted signal. A smaller conductor attenuates the signal more than a larger conductor. Typical propagation delay for a 1553B cable is 1.6 nanoseconds per foot.
SCSI-1 variations included a high voltage differential (HVD) implementation whose maximum cable length was many times that of the single-ended version. SCSI equipment, for example, allows a maximum total cable length of 25 meters using HVD, while single-ended SCSI allows a maximum cable length of 1.5 to 6 meters, depending on bus speed.
RS-485, like RS-422, can be made full-duplex by using four wires. [8] Since RS-485 is a multi-point specification, however, this is not necessary or desirable in many cases. RS-485 and RS-422 can interoperate with certain restrictions.
The maximum goodput (for example, the file transfer rate) may be even lower due to higher layer protocol overhead and data packet retransmissions caused by line noise or interference such as crosstalk, or lost packets in congested intermediate network nodes. All protocols lose something, and the more robust ones that deal resiliently with very ...
It uses an DE-9 D-Sub connector with 9 pins (hence the name), where bi-directional communication takes place over a four wire cable according to the RS-422 standard. While nowadays all post-production editing is done with a non-linear editing system, in those days editing was done linearly, using online editing. Editing machines relied heavily ...