Search results
Results From The WOW.Com Content Network
For a fuel of composition C c H h O o N n, the (higher) heat of combustion is 419 kJ/mol × (c + 0.3 h − 0.5 o) usually to a good approximation (±3%), [2] [3] though it gives poor results for some compounds such as (gaseous) formaldehyde and carbon monoxide, and can be significantly off if o + n > c, such as for glycerine dinitrate, C 3 H 6 ...
Molecular spring approximate [citation needed] 1: battery, Lithium–Manganese [19] [20] 0.83-1.01: 1.98-2.09: battery, Sodium–Sulfur: 0.72 [21] 1.23 [citation needed] 85% [22] battery, Lithium-ion [23] [24] 0.46-0.72: 0.83-3.6 [25] 95% [26] battery, Sodium–Nickel Chloride, High Temperature: 0.56: battery, Zinc–manganese (alkaline), long ...
Note that the especially high molar values, as for paraffin, gasoline, water and ammonia, result from calculating specific heats in terms of moles of molecules. If specific heat is expressed per mole of atoms for these substances, none of the constant-volume values exceed, to any large extent, the theoretical Dulong–Petit limit of 25 J⋅mol ...
If a comet with this speed fell to the Earth it would gain another 63 MJ/kg, yielding a total of 2655 MJ/kg with a speed of 72.9 km/s. Since the equator is moving at about 0.5 km/s, the impact speed has an upper limit of 73.4 km/s, giving an upper limit for the specific energy of a comet hitting the Earth of about 2690 MJ/kg.
2 (736 J⋅K −1 ⋅kg −1) is greater than that of an hypothetical monatomic gas with the same molecular mass 28 (445 J⋅K −1 ⋅kg −1), by a factor of 5 / 3 . The vibrational and electronic degrees of freedom do not contribute significantly to the heat capacity in this case, due to the relatively large energy level gaps for both ...
This is the energy per mole necessary to remove electrons from gaseous atoms or atomic ions. The first molar ionization energy applies to the neutral atoms. The second, third, etc., molar ionization energy applies to the further removal of an electron from a singly, doubly, etc., charged ion.
It is also an SI derived unit of molar thermodynamic energy defined as the energy equal to one joule in one mole of substance. [1] [2] For example, the Gibbs free energy of a compound in the area of thermochemistry is often quantified in units of kilojoules per mole (symbol: kJ·mol −1 or kJ/mol), with 1 kilojoule = 1000 joules. [3]
Specific energy is energy per unit mass, which is used to describe the chemical energy content of a fuel, expressed in SI units as joule per kilogram (J/kg) or equivalent units. [1] Energy density is the amount of chemical energy per unit volume of the fuel, expressed in SI units as joule per litre (J/L) or equivalent units. [2]