Search results
Results From The WOW.Com Content Network
[3]: 43 Points outside of these control limits are signals indicating that the process is not operating as consistently as possible; that some assignable cause has resulted in a change in the process. Similarly, runs of points on one side of the average line should also be interpreted as a signal of some change in the process.
Control charts are graphical plots used in production control to determine whether quality and manufacturing processes are being controlled under stable conditions. (ISO 7870-1) [1] The hourly status is arranged on the graph, and the occurrence of abnormalities is judged based on the presence of data that differs from the conventional trend or deviates from the control limit line.
The importance of knowing the natural process variation becomes clear when we apply statistical process control. In a stable process, the mean is on target; in the example, the target is the filling, set to 1 litre. The variation within the upper and lower control limits (UCL and LCL) is considered the natural variation of the process.
The process capability index, or process capability ratio, is a statistical measure of process capability: the ability of an engineering process to produce an output within specification limits. [1] The concept of process capability only holds meaning for processes that are in a state of statistical control. This means it cannot account for ...
The control limits are set at three standard deviations on either side of the process mean, and are known as the upper control limit (UCL) and lower control limit (LCL) respectively. [2] If the process data plotted on the control chart remains within the control limits over an extended period, then the process is said to be stable. [2] [3]
To reduce the power losses in the 5 V supply, with the introduction of the Pentium 4 microprocessor, Intel changed the processor power supply to operate on +12 V, and added the separate four-pin P4 connector to the new ATX12V 1.0 standard to supply that power.
A power supply is an electrical device that supplies electric power to an electrical load. The main purpose of a power supply is to convert electric current from a source to the correct voltage, current, and frequency to power the load. As a result, power supplies are sometimes referred to as electric power converters. Some power supplies are ...
Comparison of a linear power supply and a switched-mode power supply Linear power supply Switching power supply Notes Size and weight: 0.12 W/cm 3, 88 W/kg [28] Smaller than linear power supply. Compared to linear, a SMPS that is 20 kHz is 1/4, 100–200 kHz is 1/8, and 200 kHz–1 MHz types can be even smaller. [28]: 5–8