Search results
Results From The WOW.Com Content Network
Some have alleged that departures in normality in the process output significantly reduce the effectiveness of the charts to the point where it may require control limits to be set based on percentiles of the empirically-determined distribution of the process output [2]: 237 although this assertion has been consistently refuted. See Footnote 6.
Control charts are graphical plots used in production control to determine whether quality and manufacturing processes are being controlled under stable conditions. (ISO 7870-1) [1] The hourly status is arranged on the graph, and the occurrence of abnormalities is judged based on the presence of data that differs from the conventional trend or deviates from the control limit line.
The importance of knowing the natural process variation becomes clear when we apply statistical process control. In a stable process, the mean is on target; in the example, the target is the filling, set to 1 litre. The variation within the upper and lower control limits (UCL and LCL) is considered the natural variation of the process.
Comparison of a linear power supply and a switched-mode power supply Linear power supply Switching power supply Notes Size and weight: 0.12 W/cm 3, 88 W/kg [28] Smaller than linear power supply. Compared to linear, a SMPS that is 20 kHz is 1/4, 100–200 kHz is 1/8, and 200 kHz–1 MHz types can be even smaller. [28]: 5–8
A power supply is an electrical device that supplies electric power to an electrical load. The main purpose of a power supply is to convert electric current from a source to the correct voltage, current, and frequency to power the load. As a result, power supplies are sometimes referred to as electric power converters. Some power supplies are ...
Load regulation is the capability to maintain a constant voltage (or current) level on the output channel of a power supply despite changes in the supply's load (such as a change in resistance value connected across the supply output). [1] [2]
The line regulation for an unregulated power supply is usually very high for a majority of operations, but this can be improved by using a voltage regulator. A low line regulation is always preferred. In practice, a well regulated power supply should have a line regulation of at most 0.1%. [1]
The control limits are set at three standard deviations on either side of the process mean, and are known as the upper control limit (UCL) and lower control limit (LCL) respectively. [2] If the process data plotted on the control chart remains within the control limits over an extended period, then the process is said to be stable. [2] [3]