Ads
related to: bad torque converter problems
Search results
Results From The WOW.Com Content Network
ZF torque converter cut-away A cut-away model of a torque converter. A torque converter is a device, usually implemented as a type of fluid coupling, that transfers rotating power from a prime mover, like an internal combustion engine, to a rotating driven load. In a vehicle with an automatic transmission, the torque
Idle creep, sometimes called idle speed or just creep [citation needed] is the default speed that a vehicle with an automatic transmission will move either forward or in reverse when the change lever is in D for drive or R for reverse and the foot is taken off the brake pedal but the accelerator pedal is not depressed.
Because it was based on the "X" transmissions, its gear ratios from 1-3 were the same, with the fourth being 0.67:1. The transmission featured a split-torque application for third gear as well as a lockup in the torque converter. The XT-LOD was initially abandoned in 1966, but the design began again in 1974 because of rising gas prices.
The early model C4 (1964–1969) used a .788-inch 24-spline input shaft, which was upgraded in 1970 to 26-spline and .839-inch. The upgrade also included a matching 26-spline clutch hub. In 1971, Ford went to a 26/24-spline input shaft, meaning the torque-converter side is 26-spline and the clutch hub is 24-spline.
For 1991 GM introduced the 4T60-E which was a 4T60 with electronic controls, first seen on the new Buick Park Avenue.One benefit was that the cruise control was integrated into the gearbox' electronic control module, improving the ability to maintain a set speed while avoiding needless shifting, thus lowering fuel consumption and noise levels. [1]
Charging your phone battery to 100% consistently can damage the life of the battery over the long term. Klaus Vedfelt via Getty Images