When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Twinaxial cabling - Wikipedia

   en.wikipedia.org/wiki/Twinaxial_cabling

   The data transmission is half-duplex, balanced transmission, at 1 Mbit/s, on a single shielded, 110 Ω twisted pair. [4] With twinax, seven devices can be addressed, from workstation address 0 to 6. The devices do not have to be sequential. Twinax is a bus topology that requires termination to function properly.

3. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Duplex mismatch may be inadvertently caused when an administrator configures an interface to a fixed mode (e.g. 100 Mbit/s full-duplex) and fails to configure the remote interface, leaving it set to autonegotiate. Then, when the auto-negotiation process fails, half-duplex is assumed by the autonegotiating side of the link.

4. BroadR-Reach - Wikipedia

   en.wikipedia.org/wiki/BroadR-Reach

   Using BroadR-Reach technology in automotive enables the migration from multiple closed applications to an open Ethernet-based network.This allows automotive manufacturers to incorporate multiple electronic systems and devices, such as advanced safety features (i.e. 360-degree surround view parking assistance, rear-view cameras and collision avoidance systems) and comfort and infotainment features.

5. Medium-dependent interface - Wikipedia

   en.wikipedia.org/wiki/Medium-dependent_interface

   As long as it is enabled on either end of a link, either type of cable can be used. For auto MDI-X to operate correctly, the data rate and duplex setting on the interface must be set to auto. Auto MDI-X was developed by Hewlett-Packard engineers Daniel Joseph Dove and Bruce W. Melvin. [2]

6. DIN 72552 - Wikipedia

   en.wikipedia.org/wiki/DIN_72552

   DIN 72552 is a DIN standard for labeling the electric terminals in automotive wiring. The most frequently used labels are listed in the table below. Contact

7. Twist-on wire connector - Wikipedia

   en.wikipedia.org/wiki/Twist-on_wire_connector

   Twist-on wire connectors are a type of electrical connector used to fasten two or more low-voltage (or extra-low-voltage) electrical conductors. They are widely used in North America and several European countries in residential, commercial and industrial building power wiring, but have been banned in some other jurisdictions.