Search results
Results From The WOW.Com Content Network
Copper at red heat (300-400°C) combines directly with chlorine gas, giving (molten) copper(II) chloride. The reaction is very exothermic. [8] [15] Cu(s) + Cl 2 (g) → CuCl 2 (l) A solution of copper(II) chloride is commercially produced by adding chlorine gas to a circulating mixture of hydrochloric acid and copper. From this solution, the ...
Division 4.1: Flammable Solid . Flammable solids are any of the following four types of materials: Desensitized Explosives: explosives that, when dry, are Explosives of Class 1 other than those of compatibility group A, which are wetted with sufficient water, alcohol, or plasticizer to suppress explosive properties; and are specifically authorized by name either in the 49CFR 172.101 Table or ...
Class 1 goods are subdivided further into one of 6 distinct divisions, that describes the predominant explosive hazard that exists if that article was to detonate or activate while in transport or storage. These divisions are as follows: Class 1: Explosives. Division 1.1: Explosive that has a mass explosion hazard. A mass explosion is a ...
Class III – Petroleum, oil and lubricants (POL) for all purposes, except for operating aircraft or for use in weapons such as flamethrowers, e.g., gasoline, fuel oil, greases, coal, and coke. (Class IIIa – aviation fuel and lubricants) Class IV – Supplies for which initial issue allowances are not prescribed by approved issue tables.
The same hydrochloric acid solutions also react with acetylene gas to form [CuCl(C 2 H 2)]. Ammoniacal solutions of CuCl react with acetylenes to form the explosive copper(I) acetylide , Cu 2 C 2 . Alkene complexes of CuCl can be prepared by reduction of CuCl 2 by sulfur dioxide in the presence of the alkene in alcohol solution.
There are four means used by the agents to extinguish a fire. They act on the "fire tetrahedron": [1] Reduction or isolation of fuel. No agents currently use this as the primary means of fire suppression. Reduction of heat. Representative agents: Clean agent FS 49 C2 (NAF S 227, MH227, FM-200), Novec 1230, pentafluoroethane (NAF S125, ECARO-25).
Legend: (g)—gas; (l)—liquid; (aq)—aqueous solution; the balance of the species are in a solid phase. Atomic Energy of Canada Limited has demonstrated experimentally a CuCl electrolyzer in which hydrogen is produced electrolytically at the cathode and Cu(I) is oxidized to Cu(II) at the anode, thereby combining above steps 1 and 4 to ...
Methyltrichlorosilane is used as a reagent in silicon carbide epitaxy to introduce chloride in the gas phase. Chloride is used to reduce the tendency of silicon to react in the gas phase and thus to increase the growth rate of the process. [6] Methyltrichlorosilane is an alternative to HCl gas or to trichlorosilane.