Search results
Results From The WOW.Com Content Network
Hydrogen peroxide is a chemical compound with the formula H 2 O 2.In its pure form, it is a very pale blue [5] liquid that is slightly more viscous than water.It is used as an oxidizer, bleaching agent, and antiseptic, usually as a dilute solution (3%–6% by weight) in water for consumer use and in higher concentrations for industrial use.
Hydrogen peroxide works best as a propellant in extremely high concentrations (roughly over 70%). Although any concentration of peroxide will generate some hot gas (oxygen plus some steam), at concentrations above approximately 67%, the heat of decomposing hydrogen peroxide becomes large enough to completely vaporize all the liquid at standard pressure.
A typical mixture is 3 parts of concentrated sulfuric acid and 1 part of 30 wt. % hydrogen peroxide solution; [1] other protocols may use a 4:1 or even 7:1 mixture. A closely related mixture, sometimes called "base piranha", is a 5:1:1 mixture of water, ammonia solution (NH 4 OH, or NH 3 (aq)), and 30% hydrogen peroxide.
The peroxide value is defined as the amount of peroxide oxygen per 1 kilogram of fat or oil. Traditionally this was expressed in units of milliequivalents, although in SI units the appropriate option would be in millimoles per kilogram (N.B. 1 milliequivalents = 0.5 millimole; because 1 mEq of O 2 =1 mmol/2 of O 2 =0.5 mmol of O 2, where 2 is valence).
Amine oxides with an average chain length of 12.6 have been measured to be water-soluble at ~410 g/L. They are considered to have low bioaccumulation potential in aquatic species based on log K ow data from chain lengths less than C14 (bioconcentration factor < 87%). [ 2 ]
Hydrogen peroxide breaks down into oxygen and water. As a small amount of hydrogen peroxide generates a large volume of oxygen, the oxygen quickly pushes out of the container. [6] The soapy water traps the oxygen, creating bubbles, and turns into foam. [6] About 5-10 drops of food coloring could also be added before the catalyst to dramatize ...
For the preparation of the complex, urea is dissolved in 30% hydrogen peroxide (molar ratio 2:3) at temperatures below 60 °C. upon cooling this solution, hydrogen peroxide–urea precipitates out in the form of small platelets. [2] Akin to water of crystallization, hydrogen peroxide cocrystallizes with urea with the stoichiometry of 1:1.
When measuring water treated with water softeners, high levels of total dissolved solids do not correlate to hard water, as water softeners do not reduce TDS; rather, they replace magnesium and calcium ions, which cause hard water, with an equal charge of sodium or potassium ions, e.g. Ca 2+ ⇌ 2 Na +, leaving overall TDS unchanged [9] or even ...