Search results
Results From The WOW.Com Content Network
A quick release skewer is a mechanism for attaching a wheel to a bicycle. It consists of a rod threaded on one end and with a lever operated cam assembly on the other. The rod is inserted into the hollow axle of the wheel, a special nut is threaded on, and the lever is closed to tighten the cam and secure the wheel to the fork.
Most bicycle brake systems consist of three main components: a mechanism for the rider to apply the brakes, such as brake levers or pedals; a mechanism for transmitting that signal, such as Bowden cables, hydraulic hoses, rods, or the bicycle chain; and the brake mechanism itself, a caliper or drum, to press two or more surfaces together in ...
The cable was particularly intended for use in conjunction with bicycle brakes. The Bowden Brake was launched amidst a flurry of enthusiasm in the cycle press in 1896. It consisted of a stirrup, pulled up by the cable from a handlebar mounted lever, with rubber pads acting against the rear wheel rim.
An overrun brake (called a surge brake when invented) is a brake system commonly used on small trailers, where the motion of the trailer with respect to the towing vehicle is used to actuate the brake. The early systems were fitted with a spring system which was not very effective.
Shimano STI Dual Control shifter and brake lever: 1. Main lever 2. Release lever A. Pulling the main lever towards the rider applies the brake B. Pushing the main lever towards the center of the bike downshifts one, two or three gears depending on how far the lever is pushed (right hand shifter) or changes from a small chainring to a larger chainring (left hand shifter)
An early design for a leg mechanism called the Plantigrade Machine by Pafnuty Chebyshev was shown at the Exposition Universelle (1878). The original engravings for this leg mechanism are available. [2] The design of the leg mechanism for the Ohio State Adaptive Suspension Vehicle (ASV) is presented in the 1988 book Machines that Walk. [3]
A basic Highfield lever. A Highfield lever is a lever device which allows tension to be rapidly set up in a wire and equally rapidly released to the required extent. It is frequently used in sailing boats where tension in some part of the rigging needs to be adjusted to a pre-set amount as the wind impinges on one side of the sails or the other.
The pawl bears against the surface at an angle so that any backward motion will cause the pawl to jam against the surface and thus prevent any further backward motion. Since the backward travel distance is primarily a function of the compressibility of the high friction surface, this mechanism can result in significantly reduced backlash.