Ads
related to: phillips red head anchor bolts what size for 6x6 post
Search results
Results From The WOW.Com Content Network
The recess in the mating part must be designed to accept the particular plow bolt. ASME B18.9 standard recommends a No. 3 head (round countersunk head square neck) plow bolts and No. 7 head (round countersunk reverse key head) plow bolts for new designs. The necessary dimensions for the head styles can be found in the standard. [13] [14] [15]
In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...
A cast-in-place anchor bolt. The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]
The tension failure loads predicted by the CCD method fits experimental results over a wide range of embedment depth (e.g. 100 – 600 mm). [2] Anchor load bearing capacity provided by ACI 349 does not consider size effect, thus an underestimated value for the load-carrying capacity is obtained for large embedment depths.
Note that AN threads are different for bolts and fittings. In bolts the number refers to the diameter of the bolt whereas in a fitting it refers to the OD of the tube and thereby have different threads. For example, AN6 bolt has a 3 ⁄ 8-24 thread [3] whereas an -6 AN fitting has a 9 ⁄ 16-18 thread. [4]
Many screws used in electrical applications (for example, a typical NEMA 5-15R, breaker screws, and conduit screws) use a combination of a slotted/Phillips/Robertson screw head. A few tool manufacturers make bits to engage this screw head better than the traditional Phillips allowing for more torque before camout, for example, the C1 and C2 ...