Ads
related to: duravit toilet replacement parts inside tank arm
Search results
Results From The WOW.Com Content Network
The Duravit Design Center in Hornberg, designed by Philippe Starck, was also completed during this time. The brand is currently available in over 130 countries. With a joint venture agreement, the company began expanding its activities in China in 2003 and has been trading there since then as Duravit Chongqing Sanitaryware Co. Ltd.
As the tank water level drops, the float descends and actuates the fill valve. Water is fed to the tank to replenish its supply, and a smaller flow is directed into the overflow tube to refill the bowl. Once the flapper valve closes, the water flow from the fill valve continues until the tank level again reaches the fill line.
Toilet rim blocks are marketed as disinfectants and deodorizers, while allegedly also helping to prevent the buildup of limescale in the toilet bowl.. The composition of toilet blocks can vary, but they may contain (among other components): borax (an ingredient of many detergents), hydroxyethylcellulose (a gelling agent), troclosene sodium (a disinfectant), sodium dodecylbenzenesulfonate (a ...
A vault toilet is a non-flush toilet with a sealed container (or vault) buried in the ground to receive the excreta, all of which is contained underground until it is removed by pumping. A vault toilet is distinguished from a pit latrine because the waste accumulates in the vault instead of seeping into the underlying soil.
After flushing, the flapper valve in the water tank closes or the flush valve shuts; water lines and valves connected to the water supply refill the toilet tank and bowl. Then the toilet is again ready for use. If the forward ("flush") jet connection to the upper inlet in the toilet clogs, poor or no flushing action may result. [citation needed]
In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.