Search results
Results From The WOW.Com Content Network
Since 10 meters can frequently open up to propagate globally, most 10-meter repeaters use a CTCSS sub-audible access tone. 16 kHz-wide signals with 5 kHz deviation is normal in this band. 8 kHz-wide signals with 2.5 kHz deviation can also be found. 2.5kHz deviation is mandated by FCC rules below 29.0 MHz.
An amateur radio repeater system consisting of a 70 cm repeater and a 2-meter digipeater and iGate. Coaxial cavity RF filter at 2 meter repeater An amateur radio repeater is an electronic device that receives a weak or low-level amateur radio signal and retransmits it at a higher level or higher power, so that the signal can cover longer ...
RFinder is the official repeater directory of the following associations: [4] Amateur Radio Society Italy [7] American Radio Relay League [1] Cayman Amateur Radio Society [8] Deutscher Amateur Radio Club [9] Federacion Mexicana de Radio Experimentadores [10] L’association Réseau des Émetteurs Français [11] Lietuvos Radijo Mėgėjų ...
This is a list of repeater sites for amateur radio in Germany. It includes towers (e.g. CN Tower and Bremen TV tower), hills, mountains and other locations. List
The list of frequency ranges is called a band allocation, which may be set by international agreements, and national regulations. The modes and types of allocations within each frequency band is called a bandplan ; it may be determined by regulation, but most typically is set by agreements between amateur radio operators.
As an "all-band" transceiver, the TS-2000 offers a maximum power output of 100 watts on the HF, 6 meters, and 2 meters bands, 50 watts on 70 centimeters, and, with the TS-2000X or the optional UT-20, 10 watts on the 1.2 GHz or 23 centimeters band. The (American version) radio's main receiver covers 30 kHz through 60 MHz, 142 MHz through 152 MHz ...
A radio repeater is a combination of a radio receiver and a radio transmitter that receives a signal and retransmits it, so that two-way radio signals can cover longer distances. A repeater sited at a high elevation can allow two mobile stations, otherwise out of line-of-sight propagation range of each other, to communicate. [1]
GB3RAL, which is located at the Rutherford Appleton Laboratory, transmits continuously on a number of low-band and mid-band VHF frequencies – 40050, 50050, 60050 and 70050 kHz – as well as 28215 kHz in the 10-meter amateur band.