Search results
Results From The WOW.Com Content Network
Detail of a TFT display showing whole screen persistence artifacts TFT display showing persistence artifacts Image persistence on a BenQ GW2765HT IPS LCD monitor. Image persistence, or image retention, is a phenomenon in LCD and plasma displays where unwanted visual information is shown which corresponds to a previous state of the display.
Burn-in on a monitor, when severe as in this "please wait" message, is visible even when the monitor is switched off. Screen burn-in, image burn-in, ghost image, or shadow image, is a permanent discoloration of areas on an electronic visual display such as a cathode-ray tube (CRT) in an older computer monitor or television set. It is caused by ...
A CRT made by LP Displays. LG.Philips Displays was a joint venture created in 2001 by LG Electronics of South Korea and Philips Electronics of the Netherlands in response to the maturing cathode-ray tube (CRT) market. [9] [10] It primarily manufactured CRTs used in traditional television sets. It was the world's largest manufacturer of CRTs ...
60 fps typically. Up to 480 fps. [21] Flicker: Perceptible on lower refresh rates (60 fps and below) [22] Depends; in 2013 most LCDs used PWM to dim the backlight [23] However, since then many flicker free LCD computer monitors were introduced. [24] Does not normally occur due to a high refresh rate higher than FPS [25]
Display lag contributes to the overall latency in the interface chain of the user's inputs (mouse, keyboard, etc.) to the graphics card to the monitor. Depending on the monitor, display lag times between 10-68 ms have been measured. However, the effects of the delay on the user depend on each user's own sensitivity to it.
Low power consumption. Depending on the set display brightness and content being displayed, the older CCFT backlit models typically use less than half of the power a CRT monitor of the same size viewing area would use, and the modern LED backlit models typically use 10–25% of the power a CRT monitor would use. [149]
The difference between these two modes can only be seen on a composite monitor, where mode 0 disables the color burst, making all text appear in grayscale. Mode 1 enables the color burst, allowing for color. Mode 0 and Mode 1 are functionally identical on RGB monitors and on later adapters that emulate CGA without supporting composite color output.
On larger CRT monitors (17 in or 43 cm or larger), most people experience mild discomfort unless the refresh is set to 72 Hz or higher. A rate of 100 Hz is comfortable at almost any size. However, this does not apply to LCD monitors. The closest equivalent to a refresh rate on an LCD monitor is its frame rate, which is often locked at 60 fps ...