Search results
Results From The WOW.Com Content Network
Headlight flashing might have come into more common use as a means of attempting driver-to-driver communication by the mid-1970s, [3] when cars began to come with headlight beam selectors located on the steering column—typically activated by pulling the turn signal stalk—rather than the previous foot-operated pushbutton switches.
Directional lighting, using a switch and electromagnetically shifted reflector to illuminate the curbside only, was introduced in the rare, one-year-only 1935 Tatra. Steering-linked lighting was featured on the 1947 Tucker Torpedo's center-mounted headlight and was later popularized by the Citroën DS. This made it possible to turn the light in ...
Map lights are aimed at specific passenger positions and allow for reading without glare distraction to the driver. Some vehicles have "approach lighting" or "puddle lights" (lights that illuminate the ground outside the doors) in the exterior mirrors or lower edges of the doors, as well as interior lighting activated via key fob .
FMVSS 108 is codified in Title 49 of the Code of Federal Regulations Part 571, Section 108. [1] The most recent version was published by NHTSA for comment in December 2007, [2] and since then, it has been amended in April 2011, [3] August 2011, [4] January 2012, [5] December 2012, [6] December 2015, [7] February 2016, [8] and February 2022.
UN Regulation 37 covers motor vehicle filament lamps. These are categorized in three groups: those without general restriction that can be used in any application, those acceptable only for signalling lights (not for road illumination lamps), and those no longer allowable as light sources for new type approvals but still permitted for production as replacement parts.
hazard lights switch 85c hazard sound on Switches 81 opener 81a 1 out 81b 2 out 82 lock in 82a 1st out 82b 2nd out 82z 1st in 82y 2nd in 83 multi position switch, in 83a out position 1 83b out position 2 Relay; 85 relay coil - Important if relay coil has flyback diode in parallel 86 relay coil + Important if relay coil has diode in parallel
The Twilight Sentinel system uses a photoelectric cell to measure ambient light levels. This cell is typically mounted on the dashboard of the vehicle. [7] The system is designed to activate the vehicle's exterior lights when the ambient light falls below a certain threshold, typically corresponding to twilight conditions.
Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]