Ad
related to: stop valve leaks when closed tube frequency is measured in liters of oil
Search results
Results From The WOW.Com Content Network
The importance of valve leakage depends on what the valve is controlling. For example, a dripping tap is less significant than a leak from a six-inch pipe carrying high-pressure radioactive steam. In the United States, the American National Standards Institute specifies six different leakage classes, with "leakage" defined in terms of the full ...
BTO/C – break to open/close (valve torque) BTU – British thermal units; BTU – Board of Trade Unit (1 kWh) (historical) BU – bottom up; BUL – bottom-up lag; BUR – build-up rate; BVO – ball valve operator; bwd – barrels of water per day (often used in reference to oil production) bwipd – barrels of water injected per day
The vapour-sensing tube leak detection method involves the installation of a tube along the entire length of the pipeline. This tube – in cable form – is highly permeable to the substances to be detected in the particular application. If a leak occurs, the substances to be measured come into contact with the tube in the form of vapour, gas ...
The location of the downhole safety valve within the completion is a precisely determined parameter intended to optimise safety. There are arguments against it either being too high or too low in the well and so the final depth is a compromise of all factors.
A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure, temperature, and liquid level.
A blowout preventer (BOP) (pronounced B-O-P) [1] is a specialized valve or similar mechanical device, used to seal, control and monitor oil and gas wells to prevent blowouts, the uncontrolled release of crude oil or natural gas from a well. They are usually installed in stacks of other valves.
Some leaks may be intentional, in the case of pressure release safety valves. [5] Some emissions may originate from unintentional equipment leaks, such as from flanges or valves. [ 6 ] It is estimated that approximately 0.07-10% of methane emissions occur during transportation, storage, and distribution activities.
A pitot tube is used to measure fluid flow velocity. The tube is pointed into the flow and the difference between the stagnation pressure at the tip of the probe and the static pressure at its side is measured, yielding the dynamic pressure from which the fluid velocity is calculated using Bernoulli's equation. A volumetric rate of flow may be ...