Ads
related to: stereo to mono converter circuit board
Search results
Results From The WOW.Com Content Network
The Haeco-CSG process was designed to make stereophonic vinyl LP records compatible with mono playback equipment. These recordings were intended to make the two-channel stereo mix automatically "fold-down" properly to a single mono channel.
A bridge-tied load (BTL), also known as bridged transformerless and bridged mono, is an output configuration for audio amplifiers, a form of impedance bridging used mainly in professional audio & car applications. [1] The two channels of a stereo amplifier are fed the same monaural audio signal, with one channel's electrical polarity reversed.
The printed circuit board DSS007C shows "Ⓟ (1983) U.S. 4,384,170 and others" [11] which is an earlier patent by Forrest S. Mozer. [12] The board a has one integrated circuit only (labeled "ICS1453") and the schematic [ 13 ] shows 8 lines from the parallel port going into one chip with input pins D0-D8 that also has a "DAC output" pin going to ...
A phone connector (tip, ring, sleeve) also called an audio jack, phone plug, jack plug, stereo plug, mini-jack, or mini-stereo. This includes the original 6.35 mm (quarter inch) jack and the more recent 3.5 mm (miniature or 1/8 inch) and 2.5 mm (subminiature) jacks, both mono and stereo versions. There also exists 4.4 mm Pentaconn connectors.
Dynaco was an American hi-fi audio system manufacturer popular in the 1960s and 1970s for its wide range of affordable, yet high quality audio components. [1] Founded by David Hafler and Ed Laurent in Philadelphia, Pennsylvania in 1955, it's best known product was the ST-70 tube stereo amplifier.
A diagram of monaural sound. Monaural sound or monophonic sound (often shortened to mono) is sound intended to be heard as if it were emanating from one position. [1] This contrasts with stereophonic sound or stereo, which uses two separate audio channels to reproduce sound from two microphones on the right and left side, which is reproduced with two separate loudspeakers to give a sense of ...
Named after its early proponent audio engineer David Hafler, the circuit exploits the high amount of stereo separation between Left and Right channels and sound phase. [2] This type of system is called 2:2:4, since the rear channels are simulated from a two-channel stereo track, with no actual extra tracks encoded. The rear channels will ...
Marantz 2050L AM/FM stereo tuner (USA; 1978-1980) [1]. In electronics and radio, a tuner is a type of receiver subsystem that receives RF transmissions, such as AM or FM broadcasts, and converts the selected carrier frequency into a form suitable for further processing or output, such as to an amplifier or loudspeaker.