Ads
related to: 4.5 cm inches conversion chart
Search results
Results From The WOW.Com Content Network
The table below lists units supported by {{convert}}. More complete lists are linked for each dimension. For a complete list of all dimensions, see full list of units. {{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in ...
The recent formula used by the Brannock device assumes a foot length of 2 barleycorns less than the length of the last; thus, men's size 1 is equivalent to a last's length of 8 + 1 ⁄ 3 in (21.17 cm) and foot's length of 7 + 2 ⁄ 3 in (19.47 cm), and children's size 1 is equivalent to 4 + 1 ⁄ 4 in (10.8 cm) last's length and 3 + 7 ⁄ 12 in ...
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use.From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13]
With the average American woman's height (20 years and older) at about 5 ft 4 in (162.1 cm) (Department of Health 2012), both standard and catalog size ranges attempt to address a variety of weights or builds as well as providing for the "shorter-than-average" height woman with "petite" and "half-sizes". However "taller-than-average" women may ...
The B fitting adds 12 cm and the T height modifier 4 cm to the base hip measurement 89 + 16 = 105 cm. [13] Additionally there are a set of age based waist adjustments, such that a dress marketed at someone in their 60s may allow for a waist 9 cm larger than a dress, of the same size, marketed at someone in their 20s. The age based adjustments ...
The United States adopted the conversion factor 1 metre = 39.37 inches by an act in 1866. [30] In 1893, Mendenhall ordered the physical realization of the inch to be based on the international prototype metres numbers 21 and 27, which had been received from the CGPM, together with the previously adopted conversion factor. [31]
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
2 cm – approximate width of an adult human finger; 2.54 cm – 1 inch; 3.08568 cm – 1 attoparsec; 3.4 cm – length of a quail egg [113] 3.5 cm – width of film commonly used in motion pictures and still photography; 3.78 cm – amount of distance the Moon moves away from Earth each year [114] 4.3 cm – minimum diameter of a golf ball [115]