Ads
related to: speaker volume switch
Search results
Results From The WOW.Com Content Network
A speaker L pad is a special configuration of rheostats used to control volume while maintaining a constant load impedance on the output of the audio amplifier. [1] It consists of a parallel and a series rheostat connected in an "L" configuration.
A Motorola T-1300 series remote control is built in a telephone housing. The telephone dial is replaced with a metal plate on which is mounted a speaker, volume control and option switches. This remote control uses a two-wire circuit to control a base station. A General Electric MASTR II remote control and desk microphone.
The audio emitted by the speakers is isolated inside an enclosure, aside from a number of outlets that lead towards either a rotating horn or drum. An electric motor rotates both horn and drum at a variable speed. [12] The only control common to all Leslie speakers is a dial that controls the master volume.
Audio level at a listener's ears depends on the listening environment, listener position, speaker sensitivity as well as amplifier gain. For loudness compensation to work correctly the playback system must also accurately assume what volume level was used in mastering.
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]
Tone control is a type of equalization used to make specific pitches or frequencies in an audio signal softer or louder. It allows a listener to adjust the tone of the sound produced by an audio system to their liking, for example to compensate for inadequate bass response of loudspeakers or earphones, tonal qualities of the room, or hearing impairment.
During the late 1920s to mid-1930s, small portable PA systems and guitar combo amplifiers were fairly similar. These early amps had a "single volume control and one or two input jacks, field coil speakers" and thin wooden cabinets; remarkably, these early amps did not have tone controls or even an on-off switch. [14]
The 'log pot', that is, a potentiometer has a resistance, taper, or, "curve" (or law) of a logarithmic (log) form, is used as the volume control in audio power amplifiers, where it is also called an "audio taper pot", because the amplitude response of the human ear is approximately logarithmic. It ensures that on a volume control marked 0 to 10 ...