Ad
related to: leupold pistol scope 4x mount instructions diagram chart pdf
Search results
Results From The WOW.Com Content Network
The locking bar system allows for even stress to be distributed and prevent canting of the scope mount. Another form of scope canting is caused by the rings themselves. Many Weaver-type mounts, including many Picatinny-type scope rings and even the Redfield Type, have either two or four screws on top of the scope ring that hold the scope in place.
A Leupold telescopic sight mounted on a dovetailed rifle receiver via two scope rings From left: A sketch of a cross section on a Zeiss rail and ring mount, both with a Picatinny rail interface. Scope mounts are rigid implements used to attach (typically) a telescopic sight or other types of optical sights onto a firearm .
Leupold & Stevens, Inc. is an American manufacturer of telescopic sights, red dot sights, binoculars, rangefinders, spotting scopes, and eyewear located in Beaverton, Oregon, United States. The company, started in 1907, is on its fifth generation of family ownership.
The scope base is the attachment interface on the rifle's receiver, onto which the scope rings or scope mount are fixed. Early telescopic sights almost all have the rings that are fastened directly into tapped screw holes on the receiver, hence having no additional scope base other than the receiver top itself.
A rail system mounted on top of a SIG SG 550 A dovetail rail on a rifle receiver for mounting a sight. A rail integration system (RIS; also called a rail accessory system (RAS), rail interface system, rail system, mount, base, gun rail, or simply a rail [1]) is a generic term for any standardized attachment system for mounting firearm accessories via bar-like straight brackets (i.e. "rails ...
It is similar in concept to the earlier commercial Weaver rail mount used to mount telescopic sights, but is taller and has wider slots at regular intervals along the entire length. The MIL-STD-1913 locking slot width is 0.206 in (5.23 mm). The spacing of slot centres is 0.394 in (10.01 mm) and the slot depth is 0.118 in (3.00 mm). [8]
For example on an AR-type rifle, the mil-spec distance from center of bore to top of rail is 1.211 inches, or approximately 31 mm (1.2 in). The mount height itself, that is the distance from the top of rail to center of scope, varies, but typically lies around 36–38 mm (1.4–1.5 in) (higher and lower mounts are also readily available).
Since the BORS is mounted directly to the scope and coupled with the elevation knobs, the computer can interact with the scope by simply turning the elevation knob until the LCD displays the target’s range. [1] The kit includes the proprietary Barrett Ballistic Software that is pre-programmed with a library selected by Barrett. It also ...