Search results
Results From The WOW.Com Content Network
The Arduino software includes a serial monitor which allows simple textual data to be sent to and from the Arduino board. The RX and TX LEDs on the board flash when data is being transmitted via the FTDI chip and the USB connection to the computer (but not for serial communication on pins 0 and 1). A SoftwareSerial library allows for serial ...
The word "uno" means "one" in Italian and was chosen to mark a major redesign of the Arduino hardware and software. [7] The Uno board was the successor of the Duemilanove release and was the 9th version in a series of USB-based Arduino boards. [8] Version 1.0 of the Arduino IDE for the Arduino Uno board has now evolved to newer releases. [4]
The AVR Dragon provides in-system serial programming, high-voltage serial programming and parallel programming, as well as JTAG or debugWIRE emulation for parts with 32 KB of program memory or less. ATMEL changed the debugging feature of AVR Dragon with the latest firmware of AVR Studio 4 - AVR Studio 5 and now it supports devices over 32 KB of ...
For example, the data-acquisition mode of an instrument could be set by using the ACQuire:MODe command or it could be queried by using the ACQuire:MODe? command. Some commands can both set and query an instrument at once. For example, the *CAL? command runs a self-calibration routine on some equipment, and then returns the results of the ...
A sketch is a program written with the Arduino IDE. [72] Sketches are saved on the development computer as text files with the file extension .ino. Arduino Software (IDE) pre-1.0 saved sketches with the extension .pde. A minimal Arduino C/C++ program consists of only two functions: [73]
RS-485, also known as TIA-485(-A) or EIA-485, is a standard, originally introduced in 1983, defining the electrical characteristics of drivers and receivers for use in serial communications systems. Electrical signaling is balanced , and multipoint systems are supported.
In modern serial ports using a UART integrated circuit, all these settings can be software-controlled. Hardware from the 1980s and earlier may require setting switches or jumpers on a circuit board. The configuration for serial ports designed to be connected to a PC has become a de facto standard, usually stated as 9600/8-N-1.
To reduce the number of pins in a package, many ICs use a serial bus to transfer data when speed is not important. Some examples of such low-cost lower-speed serial buses include RS-232, DALI, SPI, CAN bus, I²C, UNI/O, and 1-Wire. Higher-speed serial buses include USB, SATA and PCI Express.