Search results
Results From The WOW.Com Content Network
Increasing the input temperature (e.g. by using an oversized ground source or by access to a solar-assisted thermal bank [10]). Accurately determining thermal conductivity will allow for much more precise ground loop [ 11 ] or borehole sizing, [ 12 ] resulting in higher return temperatures and a more efficient system.
In thermodynamics, the thermal efficiency is a dimensionless performance measure of a device that uses thermal energy, such as an internal combustion engine, steam turbine, steam engine, boiler, furnace, refrigerator, ACs etc.
Engine power is the power that an engine can put out. It can be expressed in power units, most commonly kilowatt, pferdestärke (metric horsepower), or horsepower.In terms of internal combustion engines, the engine power usually describes the rated power, which is a power output that the engine can maintain over a long period of time according to a certain testing method, for example ISO 1585.
(Note - the relation between pressure, volume, temperature, and particle number which is commonly called "the equation of state" is just one of many possible equations of state.) If we know all k+2 of the above equations of state, we may reconstitute the fundamental equation and recover all thermodynamic properties of the system.
The rate of heat flow is the amount of heat that is transferred per unit of time in some material, usually measured in watts (joules per second). Heat is the flow of thermal energy driven by thermal non-equilibrium, so the term 'heat flow' is a redundancy (i.e. a pleonasm).
Two common definitions used today are the imperial horsepower as in "hp" or "bhp" which is about 745.7 watts, and the metric horsepower as in "cv" or "PS" which is approximately 735.5 watts. The electric horsepower "hpE" is exactly 746 watts, while the boiler horsepower is 9809.5 or 9811 watts, depending on the exact year.
For a viscous, Newtonian fluid, the governing equations for mass conservation and momentum conservation are the continuity equation and the Navier-Stokes equations: = = + where is the pressure and is the viscous stress tensor, with the components of the viscous stress tensor given by: = (+) + The energy of a unit volume of the fluid is the sum of the kinetic energy / and the internal energy ...
The equation in section 310-15(C) of the National Electrical Code, called the Neher–McGrath equation (NM), may be used to estimate the effective ampacity of a cable: [3] = (+) (+), In the equation, T c {\textstyle T_{c}} is normally the limiting conductor temperature derived from the insulation or tensile strength limitations.