Ads
related to: 5w 0 ohm resistor
Search results
Results From The WOW.Com Content Network
An axial-lead through-hole zero-ohm resistor is generally marked with a single black band, [6] the symbol for "0" in the resistor color code. Surface-mount zero-ohm resistors are usually marked with a single or multiple "0" (if size allows marking), where the number of digits can indicate the tolerance or maximum resistance rating, as is the ...
These resistors are designed to withstand unusually high temperatures of up to 450 °C. [3] Wire leads in low power wirewound resistors are usually between 0.6 and 0.8 mm in diameter and tinned for ease of soldering. For higher power wire-wound resistors, either a ceramic outer case or an aluminum outer case on top of an insulating layer is used.
For example, a 10 ohm resistor connected in parallel with a 5 ohm resistor and a 15 ohm resistor produces 1 / 1/10 + 1/5 + 1/15 ohms of resistance, or 30 / 11 = 2.727 ohms. A resistor network that is a combination of parallel and series connections can be broken up into smaller parts that are either one or the other.
A similar non-standard notation using the unit symbol instead of a decimal separator is sometimes used to indicate voltages (i.e. 0V8 for 0.8 V, 1V8 for 1.8 V, 3V3 for 3.3 V or 5V0 for 5.0 V [24] [25] [26]) in contexts where a decimal separator would be inappropriate (e.g. in signal or pin names, in file names, or in labels or subscripts).
A standard TTL input at logic "1" is normally operated assuming a source current of 40 μA, and a voltage level above 2.4 V, allowing a pull-up resistor of no more than 50 kohms; whereas the TTL input at logic "0" will be expected to sink 1.6 mA at a voltage below 0.8 V, requiring a pull-down resistor less than 500 ohms. [2]
For example, the letter R is a reference prefix for the resistors of an assembly, C for capacitors, K for relays. ... (Equivalent to IEC 60750 Edition 1.0, 1983.) IEC ...