Search results
Results From The WOW.Com Content Network
A hemispherical head ("hemi-head") gives an efficient combustion chamber with minimal heat loss to the head, and allows for two large valves.However, a hemi-head usually allows no more than two valves per cylinder due to the difficulty in arranging the valve gear for four valves at diverging angles, and these large valves are necessarily heavier than those in a multi-valve engine of similar ...
Chrysler developed its first experimental hemi engine for the Republic P-47 Thunderbolt fighter aircraft. The XIV-2220 was an inverted V16 rated at 2,500 hp (1,860 kW). The P-47 was already in production with a Pratt & Whitney radial engine when the XIV-2220 flew successfully in trials in 1945 as a possible upgrade, but the war was winding down and it did not go into production.
The Polyspheric or Poly engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to the Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons.
This engine was the perfect V8 engine for the time and now it shows off the history of the HEMI engine. First Generation ‘Fire Power’ Is A Legacy HEMI Engine Skip to main content
The 426 Wedge served as Chrysler's main performance engine until the introduction of the 426 Hemi. It was initially offered as the "non-catalogued" option S42 in Chryslers (the number of such produced is uncertain), offered with 373 or 385 hp (278 or 287 kW) via a single 4-barrel carburetor (11.0:1 or 12.0:1 compression ratio, respectively), or ...
In this way, the "Hemi" moniker was used for the same kind of marketing cachet as Chrysler's 1950s-1970s Hemi V8 engines. The Hemi-6 valves are angled apart (splayed) 18 degrees (included angle) along the crankshaft axis, and the intake valves are as large as 1.96 in (50 mm). The 6 intake and 6 exhaust valves open slightly towards each other ...
Forged connecting rods used the Wedge's 3 ⁄ 8 in (9.5 mm) hardware, as opposed to the Hemi's 7 ⁄ 16 in (11.1 mm), but would nonetheless have been considered high-performance parts. [ 1 ] The intake was to be a single Carter ThermoQuad , of greater flow than any previously used, on a dual-plane intake manifold, [ 5 ] while dual four-barrels ...
Chrysler's Multi-Displacement System (MDS) is an automobile engine variable displacement technology. It debuted in 2005 on the 5.7 L modern Hemi V8.Like Mercedes-Benz's Active Cylinder Control, General Motors' Active Fuel Management, and Honda's Variable Cylinder Management, it deactivates four of the V8's cylinders when the throttle is closed or at steady speeds.