Ad
related to: db15 connector datasheet download
Search results
Results From The WOW.Com Content Network
D-subminiature connectors are often used in industrial products, the DA-15 version being commonly used on rotary and linear encoders. DB-19 connector for an external floppy drive on a Macintosh 512K. The early Macintosh and late Apple II computers used a non-standard 19-pin D-sub for connecting external floppy disk drives.
The Video Graphics Array (VGA) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [ 1 ] as well as many monitors, projectors and HD television sets.
An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.
The male PCB connector on the 3½-inch floppy drive is normally a polarized right-angle male header, which is a TE Connectivity / AMP 171826-4, [4] the straight model is AMP 171825-4. [ 5 ] The shape of the connector housing makes it very easy to determine the pin number allocations by visual inspection.
This was implemented in a multi-pin connector that had enough pins to support the majority of the common RS-232 pins; the first models used a 9-pin D connector, but this was quickly replaced by a mini-DIN-8 connector. The ports could be put into either RS-232 or RS-422 mode, which changes the behavior of some of the pins while turning others on ...
The vampire tap usually had an integrated AUI (Attachment Unit Interface) in the form of a DA-15 connector, from which a short multicore cable connected to the network card in the station (host computer). Vampire taps allowed new connections to be made on a given physical cable while the cable was in use.
DataSheets.com is a searchable database of electronic component data sheets and purchasing information. [1] The website is intended for Design engineers and Electronics purchasing agents. [ 2 ] DataSheets.com was developed by UBM in conjunction with SiliconExpert Technologies .
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.