Search results
Results From The WOW.Com Content Network
B.S is generally taken on the point of known reduced level as on the benchmark or a change point. [1] Benchmark (surveying) – fixed reference point of known elevation with respect to which RL of other points is determined. Benchmarks can be arbitrary or permanent, the former is used for calculation of reduced levels for small survey works and ...
Also amphidrome and tidal node. A geographical location where there is little or no tide, i.e. where the tidal amplitude is zero or nearly zero because the height of sea level does not change appreciably over time (meaning there is no high tide or low tide), and around which a tidal crest circulates once per tidal period (approximately every 12 hours). Tidal amplitude increases, though not ...
So if Point A is at 1,000 feet of elevation, then Point B would be at approximately 1,009.30 feet of elevation, as the reference line (0°) for zenith angles is straight up going clockwise one complete revolution, and so an angle reading of less than 90 degrees (horizontal or flat) would be looking uphill and not down (and opposite for angles ...
Transverse – intersecting at any angle, i.e. not parallel. Orthogonal (or perpendicular) – at a right angle (at the point of intersection). Elevation – along a curve from a point on the horizon to the zenith, directly overhead. Depression – along a curve from a point on the horizon to the nadir, directly below.
The term is generally applied to any item used to mark a point as an elevation reference. Frequently, bronze or aluminum disks are set in stone or concrete, or on rods driven deeply into the earth to provide a stable elevation point. If an elevation is marked on a map, but there is no physical mark on the ground, it is a spot height.
There may be obstructions or large changes of elevation between the endpoints. In these situations, extra setups are needed. Turning is a term used when referring to moving the level to take an elevation shot from a different location. To "turn" the level, one must first take a reading and record the elevation of the point the rod is located on.
Elevation (ballistics), the angle between a weapon barrel and the horizontal plane Elevation (astronomy), one component of the horizontal coordinate system Elevation (view), used in architectural drawing to represent a building facade
Geodetic latitude and geocentric latitude have different definitions. Geodetic latitude is defined as the angle between the equatorial plane and the surface normal at a point on the ellipsoid, whereas geocentric latitude is defined as the angle between the equatorial plane and a radial line connecting the centre of the ellipsoid to a point on the surface (see figure).