When.com Web Search

  1. Ads

    related to: wire connector for 4 wires and 1 chain size 2 belt buckles walmart

Search results

  1. Results From The WOW.Com Content Network
  2. Twist-on wire connector - Wikipedia

    en.wikipedia.org/wiki/Twist-on_wire_connector

    Twist-on wire connectors are not generally recommended for use with aluminum wire in the United States. [1] The U.S. Consumer Product Safety Commission disapproves wire nuts for aluminum wire; instead, special crimp connectors are called for, and as of 2011 the CPSC asserted qualified, second-preference approval of a certain kind of screw ...

  3. Ball chain - Wikipedia

    en.wikipedia.org/wiki/Ball_chain

    Common uses of ball chain are for pull cords on light fixtures [1] and ceiling fans, keychains, and as retaining chains for things such as counter pens, and dogtag chains. Typical width is size 3, or 2.4 mm, steel ball chain. In the jewelry industry, pure 925 sterling silver may be in 1 mm, 1.2 mm, 1.5 mm, 1.8 mm, and 2.2 mm ball chain.

  4. FASTON terminal - Wikipedia

    en.wikipedia.org/wiki/FASTON_terminal

    There are free-hanging wire and circuit board mounted versions of both tabs and receptacles. All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 and 0.5 mm). All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 and 0.5 mm).

  5. Ribbon cable - Wikipedia

    en.wikipedia.org/wiki/Ribbon_cable

    A spacing of 0.05 inch (1.27 mm) is the most usual, allowing for a two-row connector with a pin spacing of 0.1 inch (2.54 mm). These types are used for many types of equipment, in particular for interconnections within an enclosure. For personal computers, this size was used in floppy-disk-drive cables and older or custom Parallel ATA cables.

  6. IDC (electrical connector) - Wikipedia

    en.wikipedia.org/wiki/IDC_(electrical_connector)

    Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

  7. MC4 connector - Wikipedia

    en.wikipedia.org/wiki/MC4_connector

    MC4 connectors are successors of the MC3 Connectors, which were developed by Multi-Contact in 1996. MC3 is the abbreviation of Multi-Contact and its size 3mm PV connector with 3 mm contact pin. MC3 had certification ratings of (1000VIEC/600V UL) and 30A (10AWG PV Cable). The MC3 connectors were discontinued in 2016.