Search results
Results From The WOW.Com Content Network
Because of their high porosity and permeability, sand and gravel aquifers have higher hydraulic conductivity than clay or unfractured granite aquifers. Sand or gravel aquifers would thus be easier to extract water from (e.g., using a pumping well ) because of their high transmissivity, compared to clay or unfractured bedrock aquifers.
In 1907, Edgar Buckingham created the first water retention curve. [2] It was measured and made for six soils varying in texture from sand to clay. The data came from experiments made on soil columns 48 inch tall, where a constant water level maintained about 2 inches above the bottom through periodic addition of water from a side tube.
Hydraulic conductivity (K) is a property of soil that describes the ease with which water can move through pore spaces. It depends on the permeability of the material (pores, compaction) and on the degree of saturation. Saturated hydraulic conductivity, K sat, describes water movement through saturated media. Where hydraulic conductivity has ...
Sand is the most stable of the mineral components of soil; it consists of rock fragments, primarily quartz particles, ranging in size from 2.0 to 0.05 mm (0.0787 to 0.0020 in) in diameter. Silt ranges in size from 0.05 to 0.002 mm (0.001969 to 7.9 × 10 −5 in).
where q is the volume flux vector of the fluid at a particular point in the medium, h is the total hydraulic head, and K is the hydraulic conductivity tensor, at that point. The hydraulic conductivity can often be approximated as a scalar. (Note the analogy to Ohm's law in electrostatics. The flux vector is analogous to the current density ...
In isotropic aquifers or aquifer layers the hydraulic conductivity (K) ... The environment where a sand body was deposited controls the orientation of the sand grains ...
Hydraulic conductivity The rate of flow of water through a unit cross sectional area of an aquifer, at a unit hydraulic gradient. In US units the rate of flow is in gallons per day per square foot of cross sectional area; in SI units hydraulic conductivity is usually quoted in m 3 per day per m 2. Units are frequently shortened to metres per ...
The specific storage is the amount of water that a portion of an aquifer releases from storage, per unit mass or volume of the aquifer, per unit change in hydraulic head, while remaining fully saturated. Mass specific storage is the mass of water that an aquifer releases from storage, per mass of aquifer, per unit decline in hydraulic head: