Search results
Results From The WOW.Com Content Network
An unfinished surface is often called mill finish. These processes can improve the durability, performance and even the appearance of the surface being finished. Surface finishing is often one of the final steps taken when working metal and is essential for guaranteeing that metal components meet the requirements of the necessary finish.
The visible water surface in a toilet is the top of the trap's water seal. Each fixture drain, with exceptions, must be vented so that negative air pressure in the drain cannot siphon the trap dry, to prevent positive air pressure in the sewer from forcing gases past the water seal, and to prevent explosive sewer gas buildup.
Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock. The term tap is widely used to describe the valve used to dispense draft beer from a keg, whether gravity feed or ...
Discover the best free online games at AOL.com - Play board, card, casino, puzzle and many more online games while chatting with others in real-time.
A grid deck uses beams and diaphragms as the supporting structure. The supporting system of a grid deck is analyzed using a grillage analysis. A slab deck is one where the deck is analyzed as a plate. If the slab has a stiffness that is different in two directions (at right angles), then the deck is known and analyzed as an orthotropic deck.
A deck is also the surface used to construct a boardwalk over sand on barrier islands. Laying deck or throwing deck refers to the act of placing and bolting down cold-formed steel beneath roofing and concrete floors. This is usually done by an ironworker, sometimes in conjunction with a cement mason or carpenter. It regarded as one of the most ...
Sign in to your AOL account.
When a single stream of water hits a surface the water must go somewhere, and because the stream is uniform the water will tend to go mostly in the same direction. If a single stream hits a surface which is curved, then the stream will conform to the shape and be easily redirected with the force of the volume of water falling.