Search results
Results From The WOW.Com Content Network
Two-plane, or dynamic, balancing is necessary if the out-of-balance couple at speed needs to be balanced. The second plane used is in the opposite wheel. Two-plane, or dynamic, balancing of a locomotive wheel set is known as cross-balancing. [11] Cross-balancing was not recommended by the American Railway Association until 1931.
A balancing machine is a measuring tool used for balancing rotating machine parts such as rotors for electric motors, fans, turbines, disc brakes, disc drives, propellers and pumps. The machine usually consists of two rigid pedestals, with suspension and bearings on top supporting a mounting platform.
NASA G2 flywheel. Flywheel energy storage (FES) works by accelerating a rotor to a very high speed and maintaining the energy in the system as rotational energy.When energy is extracted from the system, the flywheel's rotational speed is reduced as a consequence of the principle of conservation of energy; adding energy to the system correspondingly results in an increase in the speed of the ...
Trevithick's 1802 steam locomotive, which used a flywheel to evenly distribute the power of its single cylinder. A flywheel is a mechanical device that uses the conservation of angular momentum to store rotational energy, a form of kinetic energy proportional to the product of its moment of inertia and the square of its rotational speed.
It had two 25-ton, 9-foot (2.7 m) diameter flywheels mounted near the center of the ship, spun at 1100 rpm by 75 hp (56 kW) AC motors. The gyroscopes' cases were mounted on vertical bearings. The gyroscopes' cases were mounted on vertical bearings.
A small reaction wheel viewed in profile A momentum/reaction wheel comprising part of a high-accuracy Conical Earth Sensor to maintain a satellite's precise attitude. A reaction wheel (RW) is an electric motor attached to a flywheel, which, when its rotation speed is changed, causes a counter-rotation proportionately through conservation of angular momentum. [1]
Dual-mass flywheel section. A dual-mass flywheel (DMF or DMFW) is a rotating mechanical device that is used to provide continuous energy (rotational energy) in systems where the energy source is not continuous, the same way as a conventional flywheel acts, but damping any violent variation of torque or revolutions that could cause an unwanted vibration.
The balance shaft runs off the small gear on the left (the large gear is for the camshaft, causing it to rotate at half the speed of the crankshaft). Balance shafts are often used in inline-four engines , to reduce the second-order vibration (a vertical force oscillating at twice the engine RPM ) that is inherent in the design of a typical ...