Ads
related to: rubber kick plate for wall hung sink 40 inches home depot kitchen garbage cans
Search results
Results From The WOW.Com Content Network
A dish draining cabinet in a Finnish home. A dish drying cabinet (Finnish astiankuivauskaappi) is a piece of kitchen shelving placed above the sink, with an open bottom and shelves made of steel wire or dowels to allow washed dishes set within to drip into the sink and air dry.
The kick space is intended to prevent potential toe injuries and allow for closer proximity to a countertop (the toes being the furthest-extending ground-level human body parts). [2] Typical dimensions are roughly 4 inches (10 cm) high by 3 inches (7.6 cm) deep. A fully enclosed cabinet base with a kick space.
Wall pot racks can appear like a horizontal bar or can look like a small hanging shelf. Bar pot racks are just a strip of metal that attaches to wall studs in two places. Pots are hung on the knob that protrude from the bar. Wall pot racks are safely attached to screws that are drilled into wall studs, not plaster or drywall.
The bar was cut to the correct length (being the width of the plates) and heated. It was then passed four or five times through the rolls of the rolling mill, to produce a thick plate about 30 inches long. Between each pass the plate is passed over (or round) the rolls, and the gap between the rolls is narrowed by means of a screw.
An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]
The Garbage Plate is an American dish consisting of hot dog or hamburger meat, hot meat sauce, and other condiments, piled atop a variety of side dishes, typically including macaroni salad and home fries.
The Pietà (Madonna della Pietà Italian: [maˈdɔnna della pjeˈta]; "[Our Lady of] Pity"; 1498–1499) is a Carrara marble sculpture of Jesus and Mary at Mount Golgotha representing the "Sixth Sorrow" of the Virgin Mary by Michelangelo Buonarroti, in Saint Peter's Basilica, Vatican City, for which it was made.
A truss connector plate, or gang plate, is a kind of tie. Truss plates are light gauge metal plates used to connect prefabricated light frame wood trusses. They are produced by punching light gauge galvanized steel to create teeth on one side. The teeth are embedded in and hold the wooden frame components to the plate and each other.