Search results
Results From The WOW.Com Content Network
The negative swing of the output will not dip below about −0.6 V, assuming a silicon PN diode. [1] A clamper (or clamping circuit or clamp) is an electronic circuit that fixes either the positive or the negative peak excursions of a signal to a defined voltage by adding a variable positive or negative DC voltage to it. [2]
The standard two-diode Baker clamp circuit, which includes the feedback current I 1 that reduces the base current I b Baker clamp alternative in a Schottky transistor. The Baker clamp is named after Richard H. Baker, who described it in his 1956 technical report "Maximum Efficiency Transistor Switching Circuits". [2]
The theorems are useful in 'circuit analysis' especially for analyzing circuits with feedback [1] and certain transistor amplifiers at high frequencies. [ 2 ] There is a close relationship between Miller theorem and Miller effect: the theorem may be considered as a generalization of the effect and the effect may be thought as of a special case ...
A transient-voltage-suppression diode can respond to over-voltages faster than other common over-voltage protection components such as varistors or gas discharge tubes. The actual clamping occurs in roughly one picosecond, but in a practical circuit the inductance of the wires leading to the device imposes a higher limit. This makes transient ...
This simple diode clamp will clamp the negative peaks of the incoming waveform to the common rail voltage. A diode clamp circuit can take a periodic alternating current signal that oscillates between positive and negative values, and vertically displace it such that either the positive or the negative peaks occur at a prescribed level. The ...
Diode circuit implementing AND in active-high logic. Note: in analog implementation exact output currents will be different from +5V supply. This circuit mirrors the previous gate: the diodes are reversed so that each input connects to the cathode of a diode and all anodes are connected together to the output, which has a pull-up resistor.
The Villard circuit, conceived by Paul Ulrich Villard, [p 1] consists simply of a capacitor and a diode. While it has the great benefit of simplicity, its output has very poor ripple characteristics. Essentially, the circuit is a diode clamp circuit. The capacitor is charged on the negative half cycles to the peak AC voltage (V pk). The output ...
When more accuracy is desired in modelling the diode's turn-on characteristic, the model can be enhanced by doubling-up the standard PWL-model. This model uses two piecewise-linear diodes in parallel, as a way to model a single diode more accurately. PWL Diode model with 2 branches. The top branch has a lower forward-voltage and a higher ...