Ad
related to: how to cut a fat quarter on the bias ruler step by step tutorial flying the a320 in aerofly fs
Search results
Results From The WOW.Com Content Network
A "fat quarter" is one square meter (or one yard by the width of the fabric, typically 42–44") folded into four and cut along the folds, thus giving a relatively square piece of fabric 50 cm on a side, as opposed to buying a quarter of a meter off the roll, resulting in a long thin piece that is only 25 cm wide.
The quarter sawing is process for rip cutting logs into lumber. It produces quarter-sawn or quarter-cut boards. The resulting lumber can also be called radially-sawn or simply quartered. Wood cut in this way is prized for certain applications, but it will tend to be more expensive as well.
A rule, now better known as a ruler and similar to a yard stick, is used to measure. Repeated measurements often use a storey pole; Carpenter's marks were made with a race knife, chisel, gouge, saw, grease pencil, chalk pencil, or lead pencil. Chalk line or ink line used to snap lines on the wood. Ink and a slurry of charcoal were used like chalk.
Lumber can be quickly flat-cut with a side-by-side set of mechanical saws. [3] A slower but sturdier method involves passing the log back and forth over a single saw. To reduce buckling that may occur along the middle of flat-cut boards, the initial cut may be offset from the diameter, and resulting sections cut further before cutting the flitches.
Diagonal- and stepped-cut rift-sawing is intermediate to flat-sawn and radial cut lumber. The angle of the bastard grain may differ along the width of the board or between opposing sides, and enhances the appearance of ray fleck. Flat-sawing is the quickest method, producing the least wood waste and largest possible boards from a log.
What You Need: A ruler, a pencil and a mirror. How to Determine If You'd Look Good With Short Hair: What You’re Looking For: If it’s less than two and a quarter inches from your ear to the
The Cooper-Harper Handling Qualities Rating Scale [1] (HQRS), sometimes Cooper-Harper Rating Scale (CHRS), is a pilot rating scale, a set of criteria used by test pilots and flight test engineers to evaluate the handling qualities of aircraft while performing a task during a flight test.
Bias tape or bias binding is a narrow strip of fabric, typically plain weave, cut on the bias. As the weave of fabric is at a 45-degree angle, the resulting fabric strip is stretchier than a strip cut on the grain. The strip also has a better drape, and conforms to curves better than fabric cut on the grain. [1]