Search results
Results From The WOW.Com Content Network
Elastomeric bearing pads are the most economical solution used in construction of large span bridges and buildings. [1] [2] Elastomeric bearings are often used in applications other than bridges, for example, supporting buildings that are built on soil that may shift slightly and cause a concrete load to crack in the absence of a elastomeric ...
A slide plate is a linear bearing that may be part of the expansion joints of bridges, high temperature horizontal ducts of water-tube boilers and other mechanical or structural engineering applications. In each case one plate is fixed and the other slides on top as expansion or contraction occurs.
There are several different types of bridge bearings which are used depending on a number of different factors including the bridge span, loading conditions, and performance specifications. [2] The oldest form of bridge bearing is simply two plates resting on top of each other. A common form of modern bridge bearing is the elastomeric bridge ...
BS 5400-9.1:1983 Steel, concrete and composite bridges. Bridge bearings. Code of practice for design of bridge bearings. (This part of standard is partially replaced by BS EN 1337-2 , BS EN 1337-3 , BS EN 1337-5 and BS EN 1337-7 , and replaced by BS EN 1337-4 and BS EN 1337-6 but remains current) BS 5400-9.2:1983 Steel, concrete and composite ...
Here is an example of a transmissibility curve. Transmissibility is the ratio of vibration of the isolated surface to that of the source. Vibrations are never eliminated, but they can be greatly reduced. The curve below shows the typical performance of a passive, negative-stiffness isolation system with a natural frequency of 0.5 Hz.
In the deck-type bridge, a wood, steel or reinforced concrete bridge deck is supported on top of two or more plate girders, and may act compositely with them. In the case of railroad bridges, the railroad ties themselves may form the bridge deck, or the deck may support ballast on which the track is laid.
The Martel bridge was adopted by the British Army in 1925 as the Large Box Girder Bridge. [2] A scaled down version of this design, the Small Box Girder Bridge, was also formally adopted by the Army in 1932. This latter design was copied by many countries, including Germany, who called their version the Kastenträger-Gerät (K-Gerät for short ...
Fluid bearings are typically quieter and smoother (more consistent friction) than rolling-element bearings. For example, hard disk drives manufactured with fluid bearings have noise ratings for bearings/motors on the order of 20–24 dB, which is a little more than the background noise of a quiet room. Drives based on rolling-element bearings ...