Search results
Results From The WOW.Com Content Network
In electronics and telecommunications, jitter is the deviation from true periodicity of a presumably periodic signal, often in relation to a reference clock signal. In clock recovery applications it is called timing jitter. [1] Jitter is a significant, and usually undesired, factor in the design of almost all communications links.
Jitter is often measured as a fraction of UI. For example, jitter of 0.01 UI is jitter that moves a signal edge by 1% of the UI duration. The widespread use of UI in jitter measurements comes from the need to apply the same requirements or results to cases of different symbol rates. This can be d
Reference clock jitter translates directly to the output, but this jitter is a smaller percentage of the output period (by the ratio above). Since the maximum output frequency is limited to f c l k / 2 {\displaystyle f_{clk}/2} , the output phase noise at close-in offsets is always at least 6 dB below the reference clock phase noise.
High clock rates impose additional design constraints on the counter: if the clock period is short, it is difficult to update the count. Binary counters, for example, need a fast carry architecture because they essentially add one to the previous counter value. A solution is using a hybrid counter architecture.
It is used to specify clock stability requirements in telecommunications standards. [1] MTIE measurements can be used to detect clock instability that can cause data loss on a communications channel. [ 2 ]
Generalized Timing Formula is a standard by VESA which defines exact parameters of the component video signal for analogue VGA display interface.. The video parameters defined by the standard include horizontal blanking (retrace) and vertical blanking intervals, horizontal frequency and vertical frequency (collectively, pixel clock rate or video signal bandwidth), and horizontal/vertical sync ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
Jitter is the undesired deviation from true periodicity of an assumed periodic signal in electronics and telecommunications, often in relation to a reference clock source. Jitter may be observed in characteristics such as the frequency of successive pulses, the signal amplitude , or phase of periodic signals.