Ad
related to: bsp to mm chart size conversion
Search results
Results From The WOW.Com Content Network
In the modern standard metric version, it is simply a size number, where listed diameter size is the major outer diameter of the external thread. For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread.
The Whitworth 55° angle remains commonly used today worldwide in form of the 15 British standard pipe threads defined in ISO 7, which are commonly used in water supply, cooling, pneumatics, and hydraulic systems. These threads are designated by a number between 1/16 and 6 that originates from the nominal internal diameter (i/d) in inches of a ...
BSP: 16.7 mm 1.337 mm 3/8" 19 TPI DIN 477-1 No. 4 DIN 477-1 No. 4 BSP: 16.7 mm 1.337 mm 3/8" 19 TPI Dish Autogas Dish No thread INT Euro Nozzle Autogas Euro No thread EXT EU-Shell (G.8) EN 15202 BSW: 21.8 mm 1.814 mm 0.858" 14 TPI EXT LH G 3/8 LH (G.33) EN 15202 BSP: 16.7 mm 1.337 mm 3/8" 19 TPI G 3/8 LH EN ISO 228-1 (G.25) EN 15202 No thread
40 mm 1.575 Ordnance QF 3-pounder Vickers: Naval gun 47 mm 1.85 inch Ordnance QF 6-pounder: Anti-tank gun 57 mm 2.244 inch Ordnance BL 10-pounder Mountain gun: Mountain gun 69.8 mm 2.75 inch 12-pounder (multiple types) Light field gun 76.2 mm 3 inch Ordnance QF 13-pounder: Light field gun 76.2 mm 3 inch 15- pounder (multiple types) Field gun 76 ...
Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
The only difference is Komatsu uses millimeter thread sizes while JIS use a BSP (British Standard Pipe) thread. JIC fitting systems have three components that make a tubing assembly: fitting, flare nut, and sleeve.
My own view is that DN is preferable because this refers to the pipe size, and any given pipe size can only be threaded to the same thread size, whereas mm is an exact mm dimension but one which has no direct relationship to the thread size, eg, 1/2" is 12.7mm not 15mm, and 3/4" is 19.1mm not 20mm, etc. —Preceding unsigned comment added by ...