When.com Web Search

  1. Ads

    related to: floor trap door kit for bathroom sink cabinet dimensions height and width

Search results

  1. Results From The WOW.Com Content Network
  2. Plumbing fixture - Wikipedia

    en.wikipedia.org/wiki/Plumbing_fixture

    In some occasional cases, a sink may have both a potable (drinkable) and a non-potable water supply. Lavatories and water closets normally connect to the water supply by means of a supply , which is a tube, usually of nominal 3/8 in ( United States ) or 10 or 12 mm diameter ( Europe and Middle East ), which connects the water supply to the ...

  3. Air gap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Air_gap_(plumbing)

    In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained properly, the air gap works as described above, and prevents drain water from the sink from backing ...

  4. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    In-line vent for under-cabinet waste plumbing In-line vent (also known as an island fixture vent , and, colloquially, a "Chicago Loop", "Boston loop" or "Bow Vent") is an alternate method permissible in some jurisdictions of venting the trap installed on an under counter island sink or other similar applications where a conventional vertical ...

  5. Trapdoor - Wikipedia

    en.wikipedia.org/wiki/Trapdoor

    A trapdoor or hatch is a sliding or hinged door that is flush with the surface of a floor, ceiling, or roof. [1] It is traditionally small in size. [2] It was invented to facilitate the hoisting of grain up through mills, however, its list of uses has grown over time. [3]

  6. Floor drain - Wikipedia

    en.wikipedia.org/wiki/Floor_drain

    Floor drain system in bathroom, Korea. A floor drain is a plumbing fixture that is installed in the floor of a structure, mainly designed to remove any standing water near it. They are usually round, but can also be square or rectangular. They usually range from 2 to 12 inches (5.1 to 30.5 cm); most are 4 inches (10 cm) in diameter.

  7. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    Essentially all plumbing fixtures including sinks, bathtubs, and showers must be equipped with either an internal or external trap. Toilets almost always have an internal trap. A bottle trap, which can be unscrewed for cleaning. Because it is a localized low-point in the plumbing, sink traps also tend to capture small and heavy objects (such as ...