Search results
Results From The WOW.Com Content Network
A preserved hit-and-miss engine: 1917 Amanco 2 + 1 ⁄ 4 hp (1.7 kW) 'Hired Man' A hit-and-miss engine or Hit 'N' Miss is a type of stationary internal combustion engine that is controlled by a governor to only fire at a set speed. They are usually 4-stroke, but 2-stroke versions were also made.
1948 Oldsmobile Straight-8 engine Oldsmobile inline 8 engine at the R. E. Olds Transportation Museum. Oldsmobile produced a straight-8 engine in the 1930s and 1940s. This was the company's top engine choice from 1932 until the 1949 introduction of the overhead valve Rocket V8, and was briefly exclusive to the Oldsmobile L-Series.
This page was last edited on 4 March 2020, at 03:26 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may ...
An illustration of several key components in a typical four-stroke engine. For a four-stroke engine, key parts of the engine include the crankshaft (purple), connecting rod (orange), one or more camshafts (red and blue), and valves. For a two-stroke engine, there may simply be an exhaust outlet and fuel inlet instead of a valve system.
The Chevrolet Stovebolt engine is a straight-six engine made in two versions between 1929 and 1962 by the Chevrolet Division of General Motors.It replaced the company's 171-cubic-inch (2.8 L) inline-four as their sole engine offering from 1929 through 1954, and was the company's base engine starting in 1955 when it added the small block V8 to the lineup.
An ignition magneto (also called a high-tension magneto) is an older type of ignition system used in spark-ignition engines (such as petrol engines). It uses a magneto and a transformer to make pulses of high voltage for the spark plugs. The older term "high-tension" means "high-voltage". [1]
Russell & Co reportedly started building steam traction engines after their 1878 incorporation, and by 1880, they employed 425 people on a seven acre site, with their own railroad sidetrack. [3] By 1884, they had become one of the largest producers of steam traction engines, plus building industrial, railroad and agricultural equipment. [2]
On some OHV engines in the 1960s, such as the Ford Taunus V4 engine and Opel CIH engine, the tappet adjustment was done by setting the height of the rocker pivot point (rather than the typical method of a rocker-end adjustment screw). On the 1965-1970 versions of the Opel CIH engine with solid tappets, the tappet adjustment was conducted with ...