Search results
Results From The WOW.Com Content Network
A reciprocating compressor or piston compressor is a positive-displacement compressor that uses pistons driven by a crankshaft to deliver gases at high pressure. [1] [2] Pressures of up to 5,000 psig are commonly produced by multistage reciprocating compressors.
A compressor increases the pressure of a fluid passing through it, so that the exit pressure is higher than the inlet pressure. Due to this property, compressors are used in a wide range of machines, such as refrigerators , cars, jet engines and industrial processes.
It offers higher efficiency than reciprocating compressors due to less losses from the clearance volume between the piston and the compressor casing, it's 40% to 50% smaller and lighter for a given capacity (which can impact material and shipping costs when used in a product), causes less vibration, has fewer components and is more reliable ...
Some turbofans have an intermediate pressure (IP) compressor located between the fan and the high pressure (HP) compressor to increase overall pressure ratio. US civil engines tend to mount the IP compressor on the LP shaft, directly behind the fan, whereas Rolls-Royce normally mount the IP compressor on a separate (i.e. IP) shaft, which is ...
Air compressor supplies air into a nail gun.. An air compressor is a machine that takes ambient air from the surroundings and discharges it at a higher pressure. It is an application of a gas compressor and a pneumatic device that converts mechanical power (from an electric motor, diesel or gasoline engine, etc.) into potential energy stored in compressed air, which has many uses.
Pumps have thousands of uses, and are the true basis to turbomachinery (Škorpík, 2017). Air compressors - Air compressors are another very popular turbomachine. They work on the principle of compression by sucking in and compressing air into a holding tank. Air compressors are one of the most basic turbomachines.
A diaphragm compressor is a variant of the classic reciprocating compressor with backup and piston rings and rod seal. The compression of gas occurs by means of a flexible membrane, instead of an intake element. The back and forth moving membrane is driven by a rod and a crankshaft mechanism.
A crosshead as part of a reciprocating piston and slider-crank linkage mechanism. Cylindrical trunk guide Hudswell Clarke Nunlow; crosshead and two slide bars. In mechanical engineering, a crosshead [1] is a mechanical joint used as part of the slider-crank linkages of long stroke reciprocating engines (either internal combustion or steam) and reciprocating compressors [2] to eliminate ...