Ads
related to: 400 sbc forged rotating assembly 392 hemi engine covers
Search results
Results From The WOW.Com Content Network
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
The new 392 HEMI, codenamed "Apache," is based on the third-generation 5.7 L HEMI, codenamed "Eagle," and shares few parts with the 392 crate engine. Special-edition Chargers and Challengers equipped with this engine, and the engines themselves, featured "392 HEMI" badging in commemorative reference to the first-generation engine of the same ...
The Polyspheric engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to its Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons.
A hemispherical head ("hemi-head") gives an efficient combustion chamber with minimal heat loss to the head, and allows for two large valves.However, a hemi-head usually allows no more than two valves per cylinder due to the difficulty in arranging the valve gear for four valves at diverging angles, and these large valves are necessarily heavier than those in a multi-valve engine of similar ...
Donovan developed the 417 cu in (6,830 cc) hemi-head V8 to overcome the tendency of 392 cu in (6,420 cc) Chryslers, then used by Top Fuel racers (many of them friends and customers of his), to crack their iron blocks. [1] He copied the 392 cu in (6,420 cc), which he admired, but tried to eliminate its deficiencies. [2]