Search results
Results From The WOW.Com Content Network
Many RTD elements consist of a length of fine wire wrapped around a heat-resistant ceramic or glass core but other constructions are also used. The RTD wire is a pure material, typically platinum (Pt), nickel (Ni), or copper (Cu). The material has an accurate resistance/temperature relationship which is used to provide an indication of temperature.
In the mid-1960s, Chrysler decided to adapt the 318 cu in (5.2 L) small block V8 into a lightweight, high output engine equally suited for drag strip or street performance use. Its block was bored out to 4.04 in (102.6 mm) but its 3.31 in (84.1 mm) stroke left unchanged, resulting in the 340 cu in (5.6 L) engine introduced for the 1968 model year.
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
For 1956, Dodge increased the displacement to 315 cu in (5.2 L) with a longer 3.80 in (96.5 mm) stroke and a taller raised-deck block, but used polyspheric rather than hemi heads on the base version. The optional high-performance D-500 version had a four-barrel carburetor and a larger-valved Dodge hemispherical combustion chambered head.
The ring under the spark plug is used to transfer the heat from the plug to the thermocouple. The gauge and cold junction are usually calibrated at room temperature, 72 °F (22 °C). Because the thermocouple is calibrated for room temperature, the gauge readings will only be 100% accurate at that engine compartment temperature.
Because these engines needed a less sophisticated rocker setup than a true hemi, with only a single rocker shaft in each head, they were also cheaper to produce and lighter. In the Chrysler literature, the Poly engines were also called single rocker shaft (SRS), while the Hemi engines were called dual rocker shaft (DRS).
A new straight-6 for Plymouth (PC/PD) and Dodge (DP/DQ) came in production in 1933, known as the "23 in block", featuring a shallow skirt and a head desk length of 580 mm, [clarify] followed by a larger ("25 in block" – 640 mm) variant for Desoto (S3) and Chrysler Royal (C16) in 1937, marking the K-Model end everywhere but in Canada. When ...
A hemispherical head ("hemi-head") gives an efficient combustion chamber with minimal heat loss to the head, and allows for two large valves.However, a hemi-head usually allows no more than two valves per cylinder due to the difficulty in arranging the valve gear for four valves at diverging angles, and these large valves are necessarily heavier than those in a multi-valve engine of similar ...