Ads
related to: banana connector plug 35mm to cm c
Search results
Results From The WOW.Com Content Network
A banana connector (commonly banana plug for the male, banana jack (or socket) for the female) is a single-wire (one conductor) electrical connector used for joining wires to equipment. The term 4 mm connector is also used, especially in Europe, although not all banana connectors will mate with 4 mm parts, and 2 mm banana connectors exist.
Connector according to T11 and T13 between 35 mm and 36 mm long. The respective angles are 45 degrees. Three-phase plugs have a dimension of 35.4 (± 0.7) × 30 (± 0.7) mm. Pin length of the connector The pins are 19 mm (± 0.5 mm) long on all types. The length of the insulation on the connector pins is 8 mm (± 0.25 mm).
This is a large enough problem that some of the connectors that do have well-defined specifications are frequently used contrary to those specifications. Not all of the connectors described in the pages in this category were designed primarily for DC power, but they have nonetheless been used for that purpose often enough to warrant inclusion here.
The Banana connector, normally only rated for extra-low voltage, is available in a high voltage variant as well. This version of the connector contains a thick shroud around both male and female connectors, permitting use at voltages of up to 30 kV. The shroud is typically deep enough to prevent connection by traditional banana plugs.
Dimensions are different - you cannot put a banana plug into a 3.5 mm phone jack and though it might go into a 1/4 inch phone jack it will not be secure or useful. Banana plugs are typically used on test and measurement equipment, and can often handle a few amps or a couple hundred volts, useful for measuring current or voltage in circuits.
The yellow P+N+E, 4h (120°) plug is a single phase connector that is in widespread use on the British Isles for 110 V building site and fairground applications. A popular model of this socket type is marketed under the brand name MK Commando [ 12 ] which leads some users to refer to all IEC 60309 sockets by the generic trademark Commando sockets .