Search results
Results From The WOW.Com Content Network
In the most basic form, a quarter-wavelength section of coaxial cable is prepared such that the inner and outer conductors are separate but still attached to the remaining cable. The outer (shield) conductor is connected to a quarter-wavelength conducting sleeve into which the cable is inserted, and the inner conductor protrudes vertically ...
The G5RV antenna is a dipole antenna fed indirectly, through a carefully chosen length of 300 Ω or 450 Ω twin lead, which acts as an impedance matching network to connect (through a balun) to a standard 50 Ω coaxial transmission line. The sloper antenna is a slanted vertical dipole antenna attached to the top of a single tower. The element ...
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
The HB9XBG antenna is a vertical dipole antenna for short wave radio amateurs. It was developed by the Swiss radio amateur Walter Kägi, whose call sign HB9XBG is also the designation of the antenna. [1] During the test phase in 2020, HB9XBG built two vertical dipoles – one for the 20-metre amateur radio band and another for the 40-metre band.
A short backfire antenna (or short back-fire, SBA, SBF or SBFA) is a type of a directional antenna, characterized by high gain, relatively small size, and narrow band. It has a shape of a disc with a straight edge, with a vertical pillar with a dipole acting as the driven element in roughly the middle and a conductive disc at the top acting as ...
Inverted-'V' antenna When the two arms of a dipole are individually straight, but bent towards each other in a 'V' shape, at an angle noticeably less than 180°, the dipole is called a 'V' antenna, and when the dipole arms' end closer to the ground than their center branch-point, the antenna is called an inverted-'V' . The inverted-'V' is ...
A patch antenna is a type of antenna with a low profile, usually consisting of a printed circuit board. It consists of a planar rectangular or circular sheet or "patch" of metal, mounted over a larger sheet of metal called a ground plane. It is the original type of microstrip antenna described by Howell in 1972. [1]
The commercially available B&W AC3-30 and B&W DS1.8-30 antennas [6] vary from the above to cover 3–30 MHz using a 90 foot length with an 18 inch spacing of the wires. The balun is a 16:1 ratio, thereby transforming the 50 Ω (ohm) coax to an 800 Ω feed at the antenna. The resistor load is also 800 Ω, non-inductive.