Search results
Results From The WOW.Com Content Network
In the most basic form, a quarter-wavelength section of coaxial cable is prepared such that the inner and outer conductors are separate but still attached to the remaining cable. The outer (shield) conductor is connected to a quarter-wavelength conducting sleeve into which the cable is inserted, and the inner conductor protrudes vertically ...
The HB9XBG antenna is a vertical dipole antenna for short wave radio amateurs. It was developed by the Swiss radio amateur Walter Kägi, whose call sign HB9XBG is also the designation of the antenna. [1] During the test phase in 2020, HB9XBG built two vertical dipoles – one for the 20-metre amateur radio band and another for the 40-metre band.
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
The G5RV antenna is a dipole antenna fed indirectly, through a carefully chosen length of 300 Ω or 450 Ω twin lead, which acts as an impedance matching network to connect (through a balun) to a standard 50 Ω coaxial transmission line. The sloper antenna is a slanted vertical dipole antenna attached to the top of a single tower. The element ...
The balun is a 16:1 ratio, thereby transforming the 50 Ω (ohm) coax to an 800 Ω feed at the antenna. The resistor load is also 800 Ω, non-inductive. This allows the antenna impedance to swing from 400–1,600 Ω over the frequency range intended and thus keep the SWR at the transmitter 2:1 or lower.
A patch antenna is a type of antenna with a low profile, usually consisting of a printed circuit board. It consists of a planar rectangular or circular sheet or "patch" of metal, mounted over a larger sheet of metal called a ground plane. It is the original type of microstrip antenna described by Howell in 1972. [1]
Yagi antenna for UHF TV reception with 22 parasitic elements; 4 reflectors attached to the vertical bracket at left, and 18 directors attached to the horizontal beam at right. The driven element is attached to the black box next to the reflectors. The antenna is most sensitive to radio waves coming from the right, parallel to the antenna's axis.
Another common construction method is to use two parallel central support booms that also acts as the transmission line, mounting the dipoles on the alternate booms. Other forms of the log-periodic design replace the dipoles with the transmission line itself, forming the log-periodic zig-zag antenna. [3]