Search results
Results From The WOW.Com Content Network
A Tower Mounted Amplifier (TMA), or Mast Head Amplifier (MHA), is a low-noise amplifier (LNA) mounted as close as practical to the antenna in mobile masts or base transceiver stations. A TMA reduces the base transceiver station noise figure (NF) and therefore improves its overall sensitivity ; in other words the mobile mast is able to receive ...
A digital controller may apply corrections to improve the measurement. [5] A significant drawback of a resistor sensor is the unavoidable electrical connection between the current to be measured and the measurement circuit. An isolation amplifier can provide electrical isolation between measured current and the rest of the measurement circuit ...
In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...
The Cimple TV Antenna Amplifier is a powerful distribution amplifier with an adjustable gain feature that reaches up to 24 decibels. Simply turn the adjustment knob to the amount of gain needed ...
A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .
Neon, like other noble gases, has a high breakdown voltage, so that normally current will not flow across it. However, a direct lightning strike (such as on a radio tower antenna) will cause the shunt to arc and conduct the massive amount of electricity to ground, protecting transmitters and other equipment.
A directional SWR meter measures the magnitude of the forward and reflected waves by sensing each one individually, with directional couplers. A calculation then produces the SWR. A simple directional SWR meter. Referring to the above diagram, the transmitter (TX) and antenna (ANT) terminals connect via an internal transmission line.
A transmitting antenna is supplied with power by a transmission line connecting the antenna to a radio transmitter. The power accepted by the antenna is the power supplied to the antenna's terminals. Losses prior to the antenna terminals are accounted for by separate impedance mismatch factors which are therefore not included in the calculation ...