Ads
related to: usb hub length limit change to 2 phase switch
Search results
Results From The WOW.Com Content Network
For example, if a USB 1.1 device is connected to a port on a USB 2.0 hub, then the TT would automatically recognize and translate the USB 1.1 signals to USB 2.0 on the uplink. However, the default design is that all lower-standard devices share the same transaction translator and thus create a bottleneck, a configuration known as the single ...
High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0. High-speed devices must also be capable of falling-back to full-speed as well, making high-speed devices backward compatible with USB 1.1 hosts. Connectors are identical for USB 2.0 and USB 1.x. SuperSpeed (SS) rate of 5.0 Gbit/s. The written USB 3.0 specification was ...
USB 2.0 was released in April 2000, adding a higher maximum signaling rate of 480 Mbit/s (maximum theoretical data throughput 53 MByte/s [25]) named High Speed or High Bandwidth, in addition to the USB 1.x Full Speed signaling rate of 12 Mbit/s (maximum theoretical data throughput 1.2 MByte/s).
The Linux kernel has supported USB mass-storage devices since version 2.3.47 [3] (2001, backported to kernel 2.2.18 [4]).This support includes quirks and silicon/firmware bug workarounds as well as additional functionality for devices and controllers (vendor-enabled functions such as ATA command pass-through for ATA-USB bridges, used for S.M.A.R.T. or temperature monitoring, controlling the ...
The USB 3.0 Micro-B plug effectively consists of a standard USB 2.0 Micro-B cable plug, with an additional 5 pins plug "stacked" to the side of it. In this way, cables with smaller 5 pin USB 2.0 Micro-B plugs can be plugged into devices with 10 contact USB 3.0 Micro-B receptacles and achieve backward compatibility.
For example, a USB 2 PCIe host controller card that presents 4 USB "Standard A" connectors typically presents one 4-port EHCI and two 2-port OHCI controllers to system software. When a high-speed USB device is attached to any of the 4 connectors, the device is managed through one of the 4 root hub ports of the EHCI controller.