When.com Web Search

  1. Ads

    related to: difference between aac and sbc trucks diesel fuel injection

Search results

  1. Results From The WOW.Com Content Network
  2. Stratified charge engine - Wikipedia

    en.wikipedia.org/wiki/Stratified_charge_engine

    With the stratified-charge application, the 3.0L V-6 will continue to employ direct fuel injection, but the injectors have been redesigned to spray under higher pressure later in the intake stroke, just before compression, and the fuel is shaped to arrive in certain areas within the cylinder to optimize combustion.

  3. Chevrolet small-block engine (first- and second-generation)

    en.wikipedia.org/wiki/Chevrolet_small-block...

    The LS9 and LT9 engines were replaced for 1987 by the L05 TBI (throttle-body fuel injection) engines. Most of the small-block engines in this timeframe were built at either the Flint engine plant in south Flint, Michigan, or at St. Catharines, Ontario. The Flint plant was producing about 5,200 engines per day in the mid-1980s, and had a slower ...

  4. Idle air control actuator - Wikipedia

    en.wikipedia.org/wiki/Idle_air_control_actuator

    An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.

  5. Chevrolet 90° V6 engine - Wikipedia

    en.wikipedia.org/wiki/Chevrolet_90°_V6_engine

    The LB1 used in trucks and vans was referred to as Vortec in Chevrolet literature (named after a combustion chamber design known as a swirl port which twists the fuel mix from the intake ports as introduced with the Cavalier's 2.0L engine), and this name continued to be used with all truck and van 4.3 L (262 cu in) V6s until 2014.

  6. Fuel injection - Wikipedia

    en.wikipedia.org/wiki/Fuel_injection

    Prior to 1979, the electronics in fuel injection systems used analogue electronics for the control system. The Bosch Motronic multi-point fuel injection system (also amongst the first systems where the ignition system is controlled by the same device as the fuel injection system) was the first mass-produced system to use digital electronics.

  7. Unit injector - Wikipedia

    en.wikipedia.org/wiki/Unit_injector

    Early Lucas electronic diesel unit injector. A unit injector (UI) is a high-pressure integrated direct fuel injection system for diesel engines, combining the injector nozzle and the injection pump in a single component. The plunger pump used is usually driven by a shared camshaft. In a unit injector, the device is typically lubricated and ...

  8. This is why you'd pick a diesel in 2024 - AOL

    www.aol.com/why-youd-pick-diesel-2024-140000824.html

    Pro: Diesel is also very efficient; even the U.S. Department of Energy says some diesel engines can go 20% to 35% farther on a gallon of fuel than their gasoline-powered counterparts.

  9. General Motors 122 engine - Wikipedia

    en.wikipedia.org/wiki/General_Motors_122_engine

    This engine was similar to the LQ5, except that it used a two-barrel carburetor instead of a throttle-body fuel injection system. This engine was used in the Chevrolet S-10 and GMC S-15 compact pickup trucks and their Blazer and Jimmy counterparts until 1985, when it was replaced by the 2.5-liter Tech IV engine. This engine produced 83 hp (62 ...