Search results
Results From The WOW.Com Content Network
Most deaerators are designed to remove oxygen down to levels of 7 parts per billion by weight or less, as well as essentially eliminating carbon dioxide. [3] [4] The deaerators in the steam generating systems of most thermal power plants use low pressure steam obtained from an extraction point in their steam turbine system.
The steam heats the water in the tank; The water in the tank serves as a surge volume within the steam plant. The deaerating feed tank's surge volume allows the ship to change "bells" (steam turbine power output) and change the ship's speed without running the feed pump dry or flooding the turbines with liquid water.
The spray type deaerator is similar to the tray type deaerator. The water is sprayed into a steam atmosphere and most of the oxygen and non-condensables are released to the steam. The water then falls to the steam scrubber where the slight pressure loss causes the water to flash a little bit which also aids the removal of oxygen and non ...
The steam generating boiler has to produce steam at the high purity, pressure and temperature required for the steam turbine that drives the electrical generator. Geothermal plants do not need boilers because they use naturally occurring steam sources. Heat exchangers may be used where the geothermal steam is very corrosive or contains ...
The fuel consumption required to generate superheated steam is greater than that required to generate an equivalent volume of saturated steam. However, the overall energy efficiency of the steam plant (the combination of boiler, superheater, piping and machinery) generally will be improved enough to more than offset the increased fuel consumption.
"Common injection points are just after the condensate polisher and again at the deaerator outlet." [ 1 ] This forms a thicker protective layer of hematite (Fe 2 O 3 ) on top of the magnetite. This is a denser, flatter film (vs. the undulation scale with OT) so that there is less resistance to water flow compared to AVT. [ 2 ]
They can use a gas turbine to produce high-reliability electricity for campus use. The HRSG can recover the heat from the gas turbine to produce steam/hot water for district heating or cooling. [1] Large ocean vessels (e.g., Emma Maersk) make use of heat recovery so that their oil-fired boilers can be shut down while underway. [1]
A deaerator is a special case of the open feedwater heater which is specifically designed to remove non-condensable gases from the feedwater. Closed feedwater heaters are typically shell and tube heat exchangers where the feedwater passes throughout the tubes and is heated by turbine extraction steam.