When.com Web Search

  1. Ads

    related to: phoenix connector 12 pin plug on bumper pull truck and camper trailer lights

Search results

  1. Results From The WOW.Com Content Network
  2. Trailer connectors in military organizations - Wikipedia

    en.wikipedia.org/wiki/Trailer_connectors_in...

    Pin A is for activation of so-called Blackout Mode. It turns off all the lights except convoy lighting if it is active. The lighting inside the vehicle shall also be extinguished if it is not specifically shaded. Pin C is for Convoy Lamps, which is the special convoy lighting, corresponding to the tail lights, to be used while driving in the dark.

  3. Trailer connectors in North America - Wikipedia

    en.wikipedia.org/wiki/Trailer_connectors_in...

    Flat 5-pin connector (Towing vehicle side) This contact is not as common, but is compatible with the 4-pin connector in the way that a towing vehicle with this connector can be connected to a trailer with the 4-pin flat plug. The extra connection is often used to block the surge brakes when reversing with the trailer. #

  4. ISO standards for trailer connectors - Wikipedia

    en.wikipedia.org/wiki/ISO_standards_for_trailer...

    7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.

  5. Trailer connector - Wikipedia

    en.wikipedia.org/wiki/Trailer_Connector

    A trailer connector is a multi-pole electrical connector between a towing vehicle (car, truck) and a trailer. It is intended primarily to supply automotive lighting on the trailer, but also provide management and supply to other loads. It is also referred to as "trailer wire," "trailer cable," or "trailer connecting cable."

  6. Trailer connectors in Europe - Wikipedia

    en.wikipedia.org/wiki/Trailer_connectors_in_Europe

    Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...

  7. Fifth-wheel coupling - Wikipedia

    en.wikipedia.org/wiki/Fifth-wheel_coupling

    The coupling consists of a kingpin, a 2-or-3 + 1 ⁄ 2-inch-diameter (50.8 or 88.9 mm) vertical steel pin protruding from the bottom of the front of the semi-trailer, and a horseshoe-shaped coupling device called a fifth wheel on the rear of the towing vehicle. As the connected truck turns, the downward-facing surface of the semi-trailer (with ...