Search results
Results From The WOW.Com Content Network
Tube sinking, also known as free tube drawing, reduces the diameter of the tube without a mandrel inside the tube. The inner diameter is determined by the inner and outer diameter of the stock tube, the outer diameter of the final product, the length of the die landing, the amount of back tension, and the friction between the tube and the die. [3]
The ends of the outer tube are sealed (usually by a blown glass ring seal), forming a water jacket, and is fitted with side ports near the ends for cooling fluid inflow and outflow. The ends of the inner tube, that carries the vapor and condensed liquid, are open.
Glass tubes are produced in various types of glass and in diameters ranging from a few millimeters to several centimeters. In most production processes, an "infinitely long" glass tube is drawn directly from the melt, from which approximately 1.5 m long pieces are chopped off after passing a roller track up to the drawing machine.
The second number represents the inner diameter of the hole in the middle of the ball or socket, which leads to the inner diameter of the tube fused to the joint. [5] Ground-glass ball (left) and socket (right) joints. The ground-glass surfaces are shown with increased shading.
H is a half shade device which divides the field of polarized light emerging out of the Nicol P into two halves, generally of unequal brightness. T is a glass tube in which an optically active solution is filled. The light, after passing through T, is allowed to fall on the analyzing Nicol A which can be rotated about the axis of the tube.
Scientific glass blowing, which is practiced in some larger laboratories, is a specialized field of glassblowing. Scientific glassblowing involves precisely controlling the shape and dimension of glass, repairing expensive or difficult-to-replace glassware, and fusing together various glass parts.
The technique is known in the glass industry as "spinning". The centrifugal force pushes the molten glass against the mold wall, where it solidifies. The cooling process often takes between 16 and 72 hours depending on the impurities or volume of material. Typical products made using this process are television tubes and missile nose cones.
A tube, or tubing, is a long hollow cylinder used for moving fluids (liquids or gases) or to protect electrical or optical cables and wires. The terms " pipe " and "tube" are almost interchangeable, although minor distinctions exist — generally, a tube has tighter engineering requirements than a pipe.