Search results
Results From The WOW.Com Content Network
A crack arrestor (otherwise known as a rip-stop doubler) is a structural engineering device. Being typically shaped into ring or strip, and composed of a strong material, it serves to contain stress corrosion cracking or fatigue cracking, helping to prevent the catastrophic failure of a device.
Flashback arrestors with different size and flow rate, and different connections. A flashback arrestor [1] or flash arrestor is a gas safety device most commonly used in oxy-fuel welding and cutting to stop the flame or reverse flow of gas back up into the equipment or supply line. It protects the user and equipment from damage or explosions.
Powerline worker performs maintenance of a lightning arrester on an electrical transmission tower in New Brunswick, Canada. A lightning arrester (alternative spelling lightning arrestor) (also called lightning isolator) is a device, essentially an air gap between an electric wire and ground, used on electric power transmission and telecommunication systems to protect the insulation and ...
Screwfix Direct Limited, trading as Screwfix, is a retailer of trade tools, accessories and hardware products based in the United Kingdom. [6] Founded in 1979 as the Woodscrew Supply Company, the company was acquired in July 1999 by Kingfisher plc , which also owns B&Q , and is listed on the London Stock Exchange .
A flame arrester during testing A flame arrester made for a 91 cm (36 inch) pipe weighing 10 tons. A flame arrester (also spelled arrestor), deflagration arrester, [1] or flame trap [2] is a device or form of construction that will allow free passage of a gas or gaseous mixture but will interrupt or prevent the passage of flame. It prevents the ...
[2] [5] The "8/20 μs" generator is designed for surge arrester testing, and produces a high-current surge into a low-impedance load. [2] On the other hand, modern electronic devices can be high and low-impedance loads simultaneously due to non-linear devices, protection circuits, and arcing in a dielectric breakdown.
If the mixture is ignited and the flame begins to travel back through the piping, the arrester will prohibit the flame from moving back to the gas source. Most detonation flame arrester applications are in systems which collect gases emitted by liquids and solids. These systems, commonly used in many industries, may be called vapor control systems.
Surge Protection Device (SPD) for installation in a low-voltage distribution board. A surge protector (or spike suppressor, surge suppressor, surge diverter, [1] surge protection device (SPD), transient voltage suppressor (TVS) or transient voltage surge suppressor (TVSS)) is an appliance or device intended to protect electrical devices in alternating current (AC) circuits from voltage spikes ...